Bearing installation: inner ring interference fit

[@simonjones7396]

Thank you, very informative

[@theoverengineer]

Glad it was helpful!

[@wissambarsoum5889]

Can you please send me more details about those rings and how to get them, thanks

[@suzesiviter6083]

Great but how do you install bearings on shaft sizes around 5mm, can I just heat it up and tap it onto the shaft?

[@theoverengineer]

Tiny bearings need no heating. SKF has a bearing installation guide book, it says on page 53, Cold mounting www.skf.com/binaries/pub12/Images/0901d1968013be94-SKF-bearing-maintenance-handbook---10001_1-EN(1)_tcm_12-463040.pdf "Mechanical methods Bearings with a cylindrical bore (d = max 80 mm) Small bearings should be mounted with an appropriate bearing fitting tool, e.g. the SKF Bearing fitting tool kit († fig. 14a)."

[@The_Mimewar]

Is there any reason you didn’t heat up the bearings? Instead of POUNDING THEM ON, do it the right way, and don’t destroy your shaft.

[@HairyTheCandyMan]

Maybe his wife wouldn't let him borrow the oven 😉

[@ivansentanu3498]

this is old comment and maybe too late too reply, I know by heat up bearing it can removed but some design, in my case the bearing was too close too rubber where the rubber cannot be removed. I think the goal of this video is not to remove bearing but how can we design so we can install and remove it easier.

[@cadillacescalade1]

The correct video is for showing us how you hv removed the bearing!!!

[@chrissanchez6675]

Never hit the inner race of the bearing for installation, always use the outer race.

[@theoverengineer]

Right on, bro, thanks for watching!

[@HairyTheCandyMan]

I always take a chisel to the rubber sheilds and inner bearing balls. The grooves it creates make them run squeeky rough.

[@maanoyaanamaano7370]

Chutke ganduu