Our brand new dremel 3000 kit did not come with Collet AND none of the shafts fit thru the hole on the collet nut. What the heck? Guess we are going back to Ace Hdwe. Okay. Collet jammed up into collet nut so with it now loosened shank fits. Glad I took another look at it.
@markanthony559 Жыл бұрын
Thanks for the link Matt i need new collets. 👍👍👍
@wood-psyche Жыл бұрын
Rings are good info to know, thanks !
@MultiTom1956 Жыл бұрын
Matt, thanks ❤ 😊
@timlist41733 ай бұрын
Got it, rings for each 16th of an inch, not how to identify the size of the shaft of the burrs?
@marthaaguero49684 ай бұрын
Thanks so much
@MattCarves4 ай бұрын
No problem 😊
@callumclark33584 ай бұрын
I want to know the diameter of the collet to fit into the Dremel. I think it’s 4.3 mm, but not sure. Do you know? ( in mm please)
@MattCarves4 ай бұрын
Yes it's 4.3 mm just measured it.
@tomrausch70143 ай бұрын
Our brand new dremel 3000 kit did not come with Collet AND none of the shafts fit thru the hole on the collet nut. What the heck? Guess we are going back to Ace Hdwe.
@tomrausch70143 ай бұрын
Found Collet, it was jammed up into collet nut so tight no tool shank would fit. Once I got it unjammed all was good. (Wife was “helping”, so that’s my excuse…..)
@MattCarves3 ай бұрын
Good to hear you got it sorted 👍
@tomrausch70143 ай бұрын
@@MattCarves I looked at it BY MYSELF…
@MountainofGrowАй бұрын
The collet is too small to fit the tool! Returning this! So confusing!
@MattCarvesАй бұрын
Are you using a Dremel tool?
@Barnaby_bo8 ай бұрын
Are the different collet sizes for different sized shafts?
@MattCarves8 ай бұрын
Yes that's correct. 1/8 is the most common burr shaft.
@Barnaby_bo8 ай бұрын
@@MattCarves so how do we know what the shaft sizes are on all the accessories bits?
@MattCarves8 ай бұрын
@Barnaby_bo when you buy them it should say or measure them