Really appreciate you posting this content. Just moved up to our first diesel launch and this is invaluable advise. Great job!
@Blackbeard.16 ай бұрын
Thank you
@12FlyVA3 жыл бұрын
Great video - you covered a lot of topics. Thanks
@ralphstacey20202 жыл бұрын
very good
@sailnav4 жыл бұрын
How about a clogged exhaust mixing elbow? On an old engine, the pipe/tube/casting, downstream of the exhaust manifold but before the muffler, can get choked with internal rust you cannot see from the outside. That's because hot gas + salt water (from the heat exchanger) + iron = a recipe for rust formation. When the rust gets so bad, the engine cannot exhale, and it runs okay at idle but at wide -open throttle it still runs....but at idle rpm (with of course much-reduced power).
@jakjarsha11076 жыл бұрын
Thanks for the upload, exactly what I was looking for. However my girlfriend doesn't find it as interesting, so I'll have to finish it later.
@cobrasvt3474 жыл бұрын
Universal diesel hell. That looks like a bulletproof Yanmar. Damn great diesel 💪
@TheCarolinaChef4 жыл бұрын
Great video!
@heavierthanheaven885 жыл бұрын
dude... this helps a novice so much.
@joecaptainoftherapy28475 жыл бұрын
Thought all videos were very good. Could not find the one I need. Currently trying to adjust the throttle linkage at the Edison pedestal after replacing ball joint attend engine at of things. Won't go into the forward gear unless done manually. Thanks for your efforts! Joe
@leewittle646 жыл бұрын
Excellent,thank you.
@mbowen0074 жыл бұрын
That was awesome!!!!
@ash81283 жыл бұрын
1:09:48 It shows a trick to find a diesel fuel system pinhole leak. Bubbles somehow appear in jar of diesel from which the lift pump is sucking in fuel. Do these bubbles signal a good fuel line or a bad one? How does the trick work? Transcript: "Start with the line from the water separator to the lift pump. Disconnect it from the separator. Place the line in a jar with a clean diesel below the level of the lift pump and operate the lever on the lift pump. If the fuel comes through without air bubbles, replace that line and go to the next one, back towards the tank. Keep repeating this process until you've isolated the leaky fuel line, valve or seal."
@kmmining13596 жыл бұрын
Good upload
@henrybalkestahl98124 жыл бұрын
Great video!! Love it!! Just one question what's the model of the Yanmar diesel being bleed about 34 min into the video?
@nipuniub5 жыл бұрын
loves it
@chuckvanderbildt5 жыл бұрын
"this would cause your boat to sink and your wallet to empty"
@michaelfutch89604 жыл бұрын
Chuck Vanderbildt If you hear a rumble, take out your wallet and start counting 😂
@dook23176 жыл бұрын
28:10 and make sure not to damage the head of the bolt..