Bent Round bar in Solidworks

[@deeppacific4539]

Exactly what I was looking for! Good job! Thanks.

[@SergioVezzani]

Exactly what I was looking for! Thanks

[@cliffbaldwincocol2136]

Nice job, well thought out!

[@ronwilcox2052]

Man, this is definitely not for beginners, which I need to build for work. Will keep looking for something a little slower and explains each move. But is definitely how to make one.

[@AndreyBlanter]

Thank you, it helped a lot!

[@BUCKY6767]

thank you , very much !! big help

[@amasll]

Showing flat patter does not need to be radish, but if you are bent to two directions perpendicular to each other? Thank you. Did not help at all. :)

[@ochivictor1688]

Nice Job and you just got a new sub .....