Bentley continental starting problem not starting tick noise

[@joseluismagallonjr6044]

Hello good afternoon , you have no clue how thankful I am with you , thanks for your video I saved over $9,560 dollars. We were about to take the engine and transmission down to change the starter. Again thank you so much and blessings for you 👍

[@spawn_mateo]

No problem will be more vid when time will let me do it. Gratefull that will help u and no cost. Subscribe any time beñtley will pop up will post it

[@joseluismagallonjr6044]

mateo hello good afternoon if is possible to call you or email you , to explain what's going on in my case and share me your point of view I'm willing to pay for your advice thanks so much

[@spawn_mateo]

@@joseluismagallonjr6044 please email me [e-mail]

[@spawn_mateo]

After u email me let me know here that email was send please pass as many information possibble faul codes whats wrong etc will try to help u best i can

[@frankmuhammad9660]

Beautiful color combo!!!

[@leoalfano2271]

Hi Sir, how can i contact you? i am based in London and i would like you to do some work on my Bentley. i tried to email but not response. maybe old email? many thanks, great videos and great help to all Bentley / VW / Audi owners.

[@spawn_mateo]

[e-mail]

[@imperialcar]

this processes don't be damage any computer ?

[@bledarjuknaj8201]

Hi I have a problem with my Bentley the car starts fine when I switch off the engine it won’t start straight away? after an hour it starts or with a jump start???? Thanks

[@kasjaved1]

Hi have the same issue with my Bentley gtc 2007 are you based in London?

[@spawn_mateo]

Yes

[@kasjaved1]

spawn_ mateo where in London? Do you think you can see what the problem is as my battery is in the other side or if you can give me your contact number

[@spawn_mateo]

[e-mail] write me there will send u my mobile or address

[@darulrahman1]

Hi, I have a problem that’s driving me nuts. So came to my car, put the key or push start button, usually dash light up all ready to turn key to start or push start. Now putting the key in or pushing the button doesn’t send power to the dash and won’t turn over. But then on some occasions(rarely) it will start like normal but as soon as I turn off the car, it will take like 24hrs for the car to start as normal again. I can try to start the car a hundred times but the dash doesn’t light up which means the car won’t start. If the dash ever lights up the car will start 100%. Car has new batteries, and terminals are tight. I just can’t figure this one out. Please help.

[@Md00069]

Hi did you manage to find a solution to this?

[@gruff7594]

Im having this same issue. So should I just untighten everything and retight everything. Please explain. Thanks

[@spawn_mateo]

Greg Ruffin check if u can hear click try to pres together female and male part from battery terminal if car starts is that issu than disconect terminal need to remove wire from switch/really and do permanent join drill hole in the terminal/ both parts and hammer there some pin off course both parts need to be pressed first. U should have one code related to voltage scan car first

[@gruff7594]

tom kub yes I have a low voltage code. Plus a code that says #50 starter relay short circuit to ground.

[@gruff7594]

Thank you all so much for your advice but I was able to wake the car up by taking jumper cables and hooking up the starter battery and main battery bridged. Hot to hot...Negative to negative! It actually started and the car continued to start after I disconnected the cable. My guess is the relay when I changed the batteries must of lost sync with one another. By using the jumper cables to reunite them it woke up! Hope this help others with this non start issue!

[@hollywoodstacks394]

@@gruff7594 hey did you have this issues ok car would not crank at all so I jump the car off it woke up let it run but after 15min just shut off no power at all but I can repeat the steps same thing over an over really dont think it's the battery

[@gruff7594]

@@hollywoodstacks394 it was my Kessy system (lil computer looking box). I had it replaced at the dealer. All is good now

[@imperialcar]

any electrical problems after this ?

[@rasheedcampbell2973]

I am having the opposite problem. My Bentley starts whenever both battery terminals are connected. The starter continuously rolls until both terminals are disconnected. Do you have any advice for me?

[@jeffreywillis3237]

I have heard the clicking sound , however that has stopped and the reading says my batteries need to be charged which I did. Now it will not start at all. Could this be a failing alternator? I have a 2006 Continental Flying Spur

[@spawn_mateo]

Try to push right wing battery terminal from wing side to middle of u car check if starts if u battery is really dead thsn turn u key left for minute or 2 and hold it that way u borrow electricity from second big battery if start that way means u battery need charging.

[@aliice3059]

Hey man. I have problem with my 2013 bently gt. I need some help

[@spawn_mateo]

What kind of problem

[@imperialcar]

, my bentley it 2012 and there is 2 black cables and a relay in the center of the cables what a need to do is put together this two black cables to avoid the relay ?

[@spawn_mateo]

No you need to take it out terminal from battery and another end from relay and than u will send that terminal under red plastic is joined together with male and female side just join them together as that makes problem. Sorry for late ansr

[@jasonle4943]

My starter battery completely dead. Just replaced new one on my 2014 Bentley Continental GT but it won't start still, just hear one single tick noise, please advice

[@spawn_mateo]

Check battery terminal and relay

[@trickstechniques6207]

Hi my Bentley has some issue with the DC converter please help me how to fix it. Battery ok Starter ok Alternator ok Current ok Even DC converter is ok But the problem is the two small wires connected with the converter 1 have current but the ground is not working When I try directly the converter is working properly Please help me to solve this issue thanks. Bentley continental GT 2005

[@spawn_mateo]

Try to take battery plastic out under u have terminal to battery and that terminal is connected under plastic u will see it will move out is pressed together or if diferent issue try to check ground

[@spawn_mateo]

Mean battery for starter not main battery

[@trickstechniques6207]

@@spawn_mateo the issue is on electric module ground wire but I can't find the other side of that wire because it's going somewhere together the bunch of wires.if I connect directly it's working but that was not solution.if you have any idea the wire going where then reply me. The one red+green wire is going on the other side in the fuse box but the red+yellow wire I didn't understand going front or where because it's not working.

[@trickstechniques6207]

@@spawn_mateo yes the starter battery.

[@spawn_mateo]

@@trickstechniques6207 u need to find electrical diagram if u have vw audi software and u will have it i am aut of my computer and all data at the moment as i am on holiday

[@ghanims7601]

I have the same issue now in my Bentley and my dealer is telling me to change the starter even i showed him your video but he still telling me starter i don’t know what to do he’s asking too much for starter change

[@spawn_mateo]

Where u come from if london let me know

[@joseluismagallonjr6044]

mateo hello good afternoon if is possible to call you or email you , to explain what's going on in my case and share me your point of view I'm willing to pay for your advice thanks so much

[@spawn_mateo]

Write me an email [e-mail] will try to help u best i can

[@NT-qw8qh]

Mateo hi, i would like to send you a photo to ask for precisely to put the screw. Can you please send me you email ? Thanks

[@spawn_mateo]

Join both male and female part together drill hole throw both of them than hammer there something or put screw. What i am using usually is lockin pin from drive belt tensionner audi 2.0l as have them plenty. Good luck

[@NT-qw8qh]

spawn_ mateo actually i did take off the hard plastic cover and the cable to terminal i can see there is male female but they look tight and did not feel loose it has production date 2003 VW . The relay does not get hot but few times it felt vibrating . That s why i wanted to send you the photos because i might take it out and squeeze it with a wise. I appreciate your quick response.

[@spawn_mateo]

@@NT-qw8qh think u problem may be somwhere else like discharge battery etc if terminal is tight just connect maybe charger 4 u battery.

[@NT-qw8qh]

spawn_ mateo i have a charger for each battery and both r new. I am going to check the battery relay 432 if ok then i will check the battery selenoid. Will let u the outcome . Thanks

[@lakewoodcollision8708]

You never explained nothing this is Useless worthless

[@bledarjuknaj8201]

Hi I have a problem with my Bentley the car starts fine when I switch off the engine it won’t start straight away? after an hour it starts or with a jump start???? Thanks