Best CNC clamping method for your CNC router table, DIY CNC router clamps that work

In this video I show you my CNC clamping method. It is a practical method to clamp material on the CNC router. With these CNC router clamps no t-slots or drive-in nuts are needed. This cnc clamping technique requires only some holes in your CNC router table.
Just watch this video to see how these CNC clamps actually work.
The diameter of these holes doesn’t need to be big in order to have a good grip, 0,4” (10mm) are enough. The table does not lose any stability like this.
If you constantly have new ideas and usually need different sizes of CNC router clamps, then this is a great clamping system for you.….I’m absolutely convinced of this.
I have tried several work holding methods before and I like this the most. It is very easy and cheap to make and a very flexible solution.
This is the link to the video that shows you how I made these hold down devices.
• CNC clamping fixtures ...

[@sebaschtl9710]

thanks for this idea. I will do it like you. The system is used in mounting bicycle handlebars

[@jonatansanblasgarcia2316]

Me parece una idea buenísima , me encanta

[@andysworkbench]

gracias amigo😃

[@Larry123456789ist]

Where can i buy these from. I am interested in buying them. I only have access to a 4'x8' cnc table.

[@nacefsofiene4828]

thank you ...but you need to describe how to build these clamps.

[@andysworkbench]

Hi, thanks for your comment. This is the link to the video where you can see how I made these clamps kzbin.info/www/bejne/jZKwgZJphtSkkLs