Best Platform For An LS Swap Beginner?

Welcome to the 2nd channel of Krusty Classics Garage! Just wanted to bring you guys a short video on what I think is the best platform/vehicles to do your first LS swap on.
DONT FORGET THE MAIN CHANNEL- / @krustyclassicsgarage
WAYS TO DONATE.
Cash App- anthonymeyer55
Venmo- AnthonyMeyer5
PayPal- [e-mail]
LIKE.SUBSCRIBE.FOLLOW
Facebook- Krusty Classics Garage
Instagram- KrustyCuda

[@jiovanimagana2283]

I got a 76 C10 the aftermarket support is amazing!

[@Carolina_Big]

LS swaps and Crocs lol keep the videos coming bro

[@woody6750]

I have been inspired by your videos on ls swaps I have a 62 Buick the engine is shot I was thinking a 350 chevy but I saw your videos' on ls swaps and what the heck I always looking for a new challenge at 65 I have not quit yet.

[@JDLR956]

Good info 😎 How bout tips on how to shop for an LS and not end up with a boat anchor? Or pitfalls to avoid?

[@jasonbunting5361]

I would like to see a video on what radiator and fan you recommend? Stock 1970"s..ish radiator that came with the old car/truck or a more modern radiator like from a donor vehicle? Advantages or disadvantages of mechanical fan vs. junkyard electric fan.

[@shanewright6958]

Great info 👍👍

[@StreetersGarage]

Subscribed

[@JuanRodriguez-yl9oq]

I got an 86 C4 Corvette. lol. It’s already looking like it’s going to be an expensive platform to start with.

[@ScottLight10]

Great videos on other channel and I’m sure this one will be too. The s10 headers, drivers side do you think a front drive shaft in like a 4x4 Ranger will hit them? Thanks for all the good info.

[@krustyclassicsgarage2]

Shouldn't be close to hitting, but I can't say for sure as I've never done one.

[@luctessier2215]

For the algorithm.

[@krustyclassicsgarage2]

🫡

[@blessxd1431]

What about sn95 and new edges and foxbodys?

[@gasperooch]

Will the exhaust headers from the gmt800 or gmt900’s fit in the gmt400 trucks/suvs?

[@alvinfisherii1341]

What’s the link for that intake boot….asking for a friend lol

[@markmantey4818]

Did you get the car intake for the Cuda from a salvage yard or use a reproduction like what Dorman is selling?

[@krustyclassicsgarage2]

Got it off Facebook

[@octvio8634]

do u adjust the driveline angle since the trans may be sitting in a different angle

[@krustyclassicsgarage2]

No. If theres a difference its very minimul

[@davidlozano2344]

I am going to ls swap a 81 el Camino taking the motor and trans out should I drain the trans fluid before pulling it? And can I use the original mounts it already has? For the ls

[@krustyclassicsgarage2]

Yes. Drain oil and transmission fluid. Unless you have a spare slip yoke to put into the back of the transmission to keep the trans fluid from running out once the driveshaft is pulled out. Yes, get a set of cheap swap plates off of amazon and bolt your old motor mounts to those for the LS