bezel basic pt 1

[@Deesum88]

I never knew that you should hold off cleaning the bezel joint until the end! That makes so much sense! I know understand why bezels give me problems. Thank you

[@husseinal-tamimi3760]

Manual work very cool ... very precise and distinctive and explain ... worth seeing and follow-up ... Thank you for your quest and Ahtmacm in the deployment of these beautiful Video, ... you have my full appreciation and gratitude you very much ...

[@LukeCreates.]

Hello hope all is well great video and solder snipers where can I get those

[@deborahhardeman8802]

I am new to silversmithing, self teaching myself, for bezel silver plate or bottom plate I use 26 gage silver sheet, is this to thick????? I love the way you explain how to make a bezel.

[@Dharlanna]

Can't wait for the next one! thank you!

[@theskysthelimit9609]

Hi Soham, l was just wondering if you need a certain type of solder and flux for stainless steel, or will hardware store solder work ok for stainless, im using the 2% silver solder with handy flux?

[@zahramousivand8601]

that was perfect

[@FeliciaCantillo]

What size is the sheet metal you buy? I couldn't hear it. Also is it hard, half hard? I am new to bezel setting. Thanks

[@1soham1]

.3mm for small stones, .5mm for larger ones. if it is hard or half hard, just anneal it so it is dead soft.

[@FeliciaCantillo]

Thank you, your videos are great.

[@FeliciaCantillo]

Do you buy from Rio Grande? Where can I purchase that sheet of Silver you showed in your video?

[@jimb2855]

What size stone do you consider to be small and large?

[@shirleymason7697]

Very good. Thank you.

[@jennstumpf1]

Love this video series. I have been using sheet solder and when I look on Rio for the wire solder, find it comes in gauges. What gauge solder to use with this bezel?

[@1soham1]

22

[@1MMMlife]

@@1soham1 what is the gauge on that fine silver sheet?

[@deborahhardeman8802]

One more question, what are the snips called you snip your solder with?

[@shirleymason7697]

Again. I've made a few successful bezel cups, then warped my last one. Back to the drawing board.

[@miloszikic2772]

danas je skoro svaki zlatarski rad masinski retki su majstori koi urade nesto rucno a i jos uvek je to tajna kako napraviti prsten ili burmu da ne pominjem kako uradiri neki lancic na pr jedna burma masinski uradjena kosta oko 15.000 a ista takva rucni rad oko70.000 voleo bi da pokazem nekom mladom coveku kako sve ovo pomenuto da izradi na stari tradicionalan nacin da se razbije misterija - tajna