Binding Crossfire Receiver to Radiomaster or Jumper Radios (OpenTX)

Note We have made a mistake in the bind process with the receiver. You JUST need to apply power. (slow, blinking GREEN indicates bind mode)
How to Bind CRSF nano receiver to Open TX radios using CRSF external module.
Stuck on Bind screen?
• Crossfire Receiver Won...
No Regrets by Roa / roa_music1031
Creative Commons - Attribution 3.0 Unported - CC BY 3.0
Free Download / Stream: bit.ly/3BzQkTr
Music promoted by Audio Library • No Regrets - Roa (No C...
#TBS #Crossfirebinding #jumper #radiomaster

[@yenghooitan5666]

I'm new to drones and this is a simple and great video on how to bind crossfire to Radiomaster. Would you care to share a link on where to buy the battery that you used to power up the receiver? There's just so many types of batteries out there and I don't know which is compatible with the receiver socket. Thanks!

[@IRONQUAD]

The video shows the receiver already installed onto the flight controller and all we are doing is powering on the drone itself.

[@tito9107]

I have a Radiomaster Zorro, how do I bind a tbs crossfire nano rx to it?

[@IRONQUAD]

You need to get a TBS crossfire nano TX module and mount it in the external bay. Then, follow the steps from the start of this video link to the end of the video: kzbin.info/www/bejne/rJLJk4B4fsyVoKc

[@tito9107]

@@IRONQUAD Thank you!

[@jheath1968]

Good Day I have ordered a flywoo nano 1cell drone. It comes with a tbs crossfire receiver. I have also bought a Radiomaster tx16s hall transmitter what I want to find out is is if it will bind to this tx without a crossfire tbs nano module. If I correct I will have to get this module to make it bind. Thanking you in advance Regards Jonarhan

[@IRONQUAD]

You will need a TBS crossfire MICRO or TX / TX lite external module. The nano is not compatible with the tx16s.