Wow, outstanding setup! And so much so, that I am interested in FPV now. Never thought that would happen. Thanks so much for the upload, absolutely inspiring...
@gsansoucie8 жыл бұрын
I stumbled on this video and am amazed that plane can still fly with all that gear. This is incredible. Great video and very clear walk through.
@gsansoucie5 жыл бұрын
Three years later I stumble on the same video and my comment. I still don’t have a Bixler (yet).
@DaninVA4 жыл бұрын
Very cool setup and video! I am a little surprised that the old stock Bix will carry all that equipment.
5 жыл бұрын
Hi. I still flight my BIX3 almost all weekend and publish my videos about what a I learn with him and all can learn too. It's a great RC Airplane to learn, I say that in all my videos. The fact of BIX3 have landing gear is advantage in my opinion to learn to do great landings. And have Flaps... Be welcome and again, thanks very much for this review, best regards!
@ThatHPIGUY9 жыл бұрын
great video, I just ordered my own Bix 3.
@steone776 жыл бұрын
Nice video just purchased one of these myself ... thanks for video may thing a bit clearer
@arongatt8 жыл бұрын
thats a neat pan setup there mate .
@garrynutter8609 жыл бұрын
Nice talkthrough Mike. Well Done. Any Chance you could post some to the safety equipment you use onboard please.
@YakFPV9 жыл бұрын
nice setup ! pan camera look fluid
@JoshWeaverRC5 жыл бұрын
Great work!
@Mike_Barnard9 жыл бұрын
Hello Husky041, I use one GPS for the T1000 Return to home unit and the others for the OSD. The T1000 doesn't have an OSD on it so I have to have a separate one to show my speed and distance form home.
@husky0419 жыл бұрын
Ah, thanks. I'm planning to use an APM flight controller as I'm a little familiar with them and have one in my quadcopter. It has a separate gps/compass unit which also supplies gps to my goggles via a MinimOSD board. You probably know this already ☺
@Mike_Barnard9 жыл бұрын
No, it normally flips over on landing because of the weight of the GoPro on top. I put some tape on the bottom to prevent damage to the underside on landing.
@adlapl7 жыл бұрын
Pure beauty! :)
@bertramheath17665 жыл бұрын
Would be ausome if you could specify the fpv part names
@husky0419 жыл бұрын
Very nice, and I envy you for that workshop! I'm puzzled about your GPS though. ..you have one for your OSD on top of the motor pod, and another Hobbyking unit on the tail - boom. Why is there two? Anyway, my Bix3 arrives tomorrow 😆
@PhilipFumey9 жыл бұрын
Hi Mike, I'd be interested in the specs. Cheers and thanks for sharing.
@Mike_Barnard9 жыл бұрын
TQman, I fly it on a 3s 3300mah for about 15 mins of flight or on parallel 3s 2200mah for 20min flight time.
@jostak35779 жыл бұрын
Hi, it's really nice set up. What is the ready to fly weight?
@leemetcalfe99588 жыл бұрын
Hi there cool video what make and were did you get the 1.3ghz video equipment from. Thanks Lee
@ASBO_Rob5 жыл бұрын
Great video, But one question, How did you run it all? As in what ampage & how many BEC's did you use?
@Mike_Barnard9 жыл бұрын
Hi Philip, the specs are at the end of the video. Let me know if you want to know any thing else
@livelandings7478 жыл бұрын
Is this a standard RTF bixler? I am looking to setup a similar fpv unit with the bixler 3 and needed to know if I will need to upgrade the prop? thanks for sharing the vid
@Mike_Barnard8 жыл бұрын
Hello! Everything about the bix 3 was just standard, latter on I upgraded the ESC but apart from that it flew very nicely with standard gear.
@nealshave60858 жыл бұрын
Hi Mike - great video, thanks for sharing. I'm interested to know where its was shot, I live in Norfolk so I'm familiar with all the old airfields and this looks like East Anglia. Where did you shoot it, if you don't want to say that's ok.
@Mike_Barnard8 жыл бұрын
Hello, thanks! I fly with a club on the disused Acaster airfield just south of York.
@Garethfrostturkeythroat1134 жыл бұрын
The bixler can take a heavy payload what battery you use
@Mike_Barnard4 жыл бұрын
Hi, I used a 3400mah but it would take two for longer flights
@shipcases19515 жыл бұрын
Where did you get that gear arrangement for camera panning?
@Mike_Barnard5 жыл бұрын
shipcases1951 I made it from some old RC helicopter mAin gears
@TQman819 жыл бұрын
Maybe I didn't get it, but how big batteries are you using?
@stvdedal5 жыл бұрын
What weight your setup have?
@EnglishTurbines8 жыл бұрын
Mi Mike, its a complex set up for sure...lol...I have the T1000 stabiliser with RTH, why in gods name did they not make it automatically reset home position when it found more than six sats?...Mental....It would be really good if you could review the T1000 and clarify how to set Home and what the flashing LEDs mean, because the Manual is just nonsense.....No wait, completely useless...lol......Do you find it hard to turn the plane when the T1000 has its Sat receiver active, ie in Stab Mode..permanently?
@einsaan7 жыл бұрын
What was the flying weight with all the setup?
@wyomingoutdoors8 жыл бұрын
How much flying time do you get on the 3300mah battery? What is your final landing voltage?
@Mike_Barnard8 жыл бұрын
Hello, I get about 20 to 25 minutes. I try to land with the remaining voltage at about 11.1v
@youniles8 жыл бұрын
where did you get the camera pan setup I would really like one please help
@Mike_Barnard8 жыл бұрын
Hello, I built the pan setup my self out of an old servo powered gimbal I had. There are 360 mounts available but if you want a self centring mount that can spin 180 each direction you most likely have to build it your self. There are some out there but they are quite expensive. A quick google of RC 360 GoPro mount should but you in the right direction.
@AceadamUK9 жыл бұрын
do you use the landing gear?
@user-vb6ii6kj1z7 жыл бұрын
Hi! I have the same plane. Show the layout of equipment and tell me why 3 antennas and 3 camera?
@Mike_Barnard7 жыл бұрын
Владислав Горячев if you watch the video I explain it all. Only two antenna, one for video one for control. The two black cameras are of the video feed back to base station and the GoPro is for HD video recording.
@user-vb6ii6kj1z7 жыл бұрын
So, course 1 camera, 1 camera recording monitor, 1 camera recording on "carousel", 1 (under the wing) a record of the earth.... My God!!! Why so many? See the black camera on the "carousel" from the video surveillance kit 832 5.8 Hz. And how much all the equipment weigh?
@Mike_Barnard7 жыл бұрын
It's nice to see all angles when you finish flying! I don't know how much it all weighs, flew ok but needed a bit more weight in the tail to balance
@user-vb6ii6kj1z7 жыл бұрын
"Ladies and gentlemen! We are pleased to welcome you to our the airliner of the mega modern the next generation!!! During the flight you can enjoy a swim in the 100 metre infinity pool with sunbathing at a height of 10 miles to play Golf on the field with 40 holes, a bar, a restaurant, to visit a Brazilian festival... And now with all this try to fly up and reach the flight level...The insurance agent and the chaplain is at the end of the plane, where you will be able to deliver the bus. God bless you! In the name of father, son, and Holy spirit, Amen and goodbye."8- )))))
@nucleo17726 жыл бұрын
your flying time on this 3300mah ??
@Mike_Barnard6 жыл бұрын
maciek pawłowski I would get an easy 30 minuets flight time and if I was careful on the throttle I could push to about 40 minuets
@husky0419 жыл бұрын
Very nice, and I envy you for that workshop! I'm puzzled about your GPS though. ..you have one for your OSD on top of the motor pod, and another Hobbyking unit on the tail - boom. Why is there two? Anyway, my Bix3 arrives tomorrow 😆