Brake Bracket Build - Laser Cut Bracket

[@outsidescrewball]

Hi Mike Enjoyed the video...good explanation...happy drilling! Chuck

[@bluehandsvideo]

Thanks! :)

[@BrentRogers-yp6bc]

Would you share the file for your bracket my diff is b210

[@bluehandsvideo]

Those brackets are only for the front, I've never done a rear bracket. The brackets are for the 320/520/521/620(drum) kingpin spindles. The design has been shared on my website for years..... www.bluehandsvideo.com/brake-kit-cad.html They're pdf's, but if you print them at 1:1 you should be able to use the bracket prints as templates.

[@CompEdgeX2013]

The laser cutting looks nice. Too bad about the pierce hole but it is only cosmetic.

[@bluehandsvideo]

The big pieces don't have the pierce hole. I'm guessing they were trying to squeeze the little ones in too tightly. The pierce just off the line and then move in, but if they're not far enough off the line, it gets the divot from excess heat. You can tell they didn't pierce on the line since there's no damage on the top of the cut. I just learned this when I had some plasma cutting done.