BMW E36 - REAR JACKING POINT weld REPAIRS on my 328i Coupe

[@mikesphoenix_e46m3]

Great work and another great video steve my head was really stuck into this like i was there watching it all but you got more guts that me you just get in there and get on with it but the works looking great its really comming along now but im still getting reminded about my e36 by watching these videos maybe its not always a good thing maybe 🤣

[@HardlyExotic]

Thanks mate glad you enjoyed it. Feels like it's coming together at last now so pretty happy with the progress! Have you done much to yours this summer?

[@M3MJ]

Keep up the good work mate! Your vids helped me bite the bullet and buy a slightly rusty E36 and give welding a go for the first time.

[@HardlyExotic]

Thanks mate. Good luck on the E36, my best advice is get out of it now but you're committed for life 😂 If you're UK based and need any parts then drop me an email - www.protezioneautoworks.co.uk

[@mikesphoenix_e46m3]

Yes you starting to see light at the end of the tunnel 👍 part from changing disc n pads all round and handbrake not done alot but did shampoo the 30 year old velour seats n mats which came up nice 😅 next job might b replacing the sunroof headliner bit but apparently involves removing the sunroof cartridge to do 😬 my m3 did go on display in a museum for a week which was nice 😊

[@HardlyExotic]

Well you're still ticking bits off which is progress! I need to do a headlining in my touring bad!! It's. Along old job though. Which museum did you get the m3 in!

[@janrogala8284]

Nice work 😊

[@HardlyExotic]

Thanks buddy!

[@sannlivkoto]

awesome vid man im subbin i got a project and it will need fixing some rust can you give some advise and what welder are you using?

[@HardlyExotic]

Thanks buddy. My earlier vids show the front jacking point repairs too! For the welder I use an RTECH Mig 180

[@onebyonekeeboard8525]

you reckon it’s too late if my jack points are completely crushed?😭

[@HardlyExotic]

No, it's just the repair becomes much more complex as you will need to tie into the box section above which is fine but harder to access, you will need to trim higher into the bodywork to access this metalwork and then rewuite further repairs and paintwork etc.