BMW N63B44 Oil Leak ,Turbocharger Return Oil Cover Gasket - DIY

[@songsforever4935]

great one boss,keep posting such videos

[@bralewidowdan2987]

Exelent, it would be just little more helpful if you showed how to disconnect turbo oil drain hoses and how to connect them. I mean the pattern, since that is the most complicated job because everything is pretty tight once you return turbos. Also bank two bottom manifold clamp installation? How? No space! You didn’t show that .

[@clarkali2393]

was this oil leak causing the engine malfunction warning to come on? I have 2011 x5 50i E70 N63. I believe same as this BMW

[@SuperFastDriver]

I was loosing oil, that is a common oil leak on this engine.. for the warning light scan the car

[@JohnSmith-gj2ep]

Torque specs for all this??

[@juliolonghares8730]

Did any of that have to be torqued

[@SuperFastDriver]

Hi sorry for the incomplete video, it was not easy to capture all, cause I was alone doing it. Honestly for me the most important to be torqued was the oil return cover 10Nm .. All the rest is mostly clamps, isolation, hoses etc..

[@SuperFastDriver]

exhaust manifolds as well 20 Nm

[@ShehzalQureshi]

GREAT JOB,

[@SuperFastDriver]

Thanks 😊

[@megdadommi4420]

jag har en 750 med samma motor som misständer efter 20 min körning. får felkoder om att olika cylindrar misständer aldrig samma undrar om det är tjuvluft? har du någon erfarenhet av det?

[@SuperFastDriver]

did you replace your injectors? They must be index 11 or higher

[@StephenSwanton]

Hi, nice video, is it necessary for the alternator to be removed?

[@SuperFastDriver]

yes it must be removed, in order to get out alternator bracket..

[@boriskaraoglanov]

How did you screw torx back the vacuum tank under lower head shield ? I am ready to put back together but can't them screwed in.

[@SuperFastDriver]

I did it, with small rachet .. but you can try with small spanner and torx socket short one

[@boriskaraoglanov]

@@SuperFastDriver Heh, also tried with mini rached. But was going in little by little and end up stripping end head ( likely was able to go back and remove so going to attempt with spanner tmrw. On a side note maybe you would know, so originally i had metal vacuum tank just like on your video, but new came as a plastic although same part number. do you know if it's new replacement by bmw or mistake ?

[@SuperFastDriver]

@@boriskaraoglanov strongly recommend you do not put the plastic one.. it is for updated version of N63B44TU .. find the metal one

[@storcas1]

Can this issue also causes smoke 💨 coming out the muffler ?

[@SuperFastDriver]

unfortunately.. no.. most probably you deal with bad injectors if black smoke.. or if it’s blue.. bad stem seals

[@storcas1]

@@SuperFastDriver thank you