BMW R60/6 Fork Seal Replacement

[@steveb5584]

You made that look so easy . Thanks

[@glyncullen1540]

Awesome video. Thanks a lot .

[@DariuS152mm]

Thanks 🙂

[@chrispiatt2235]

Very nicely done; you captured everything in a nice, tight presentation. Cheers!

[@TheBMWGuy]

Thank you very much!

[@shingerz]

Great video im guessing it would be similar on a 79 r80 /7

[@hanssanders1334]

Hi, great channel! I wonder if you have a tip for the following problem with my R60/5. Drive shaft filler bolt does not come off while turning round and round... Thanks a lot in advance.

[@alexandroramos1504]

can you replace the fork's lower drain bolt at the point that you removed the fork legs? , mine broke while tightening it. cheers.

[@jamesconnors4297]

Thats a lot of fork oil . i have used a a syringe in the past to fill the forks as it seems the easiest method to get the amount right & measuring jug

[@mst10506]

Great video! Two questions about the procedure. Why not just seat the new seal into the lowers and then just slide them on? (2) Could you fill the lowers with fresh fork oil before you put them onto the upper tubes, instead of adding the oil later from above?

[@TheBMWGuy]

if you don't have a fancy fork seal driver yes you can just put them into the fork leg off the bike. also you have the put the oil in thru the top because the "drain" on the bottom of the fork also holds the fork legs onto the fork tubes

[@mst10506]

@@TheBMWGuy Thanks. Didn't realize the drain also connects the leg to the tube. I've got a 1974 R60/6 - great bike - 160k miles.

[@vespasandengines]

Dumb question, but is it the same for a 75/6?

[@TheBMWGuy]

Yes sir!

[@vespasandengines]

@@TheBMWGuy great! Oil hasn’t been changed on my 75/6 will give it a go now

[@davewoodman2867]

Usually the gear clamps are turned to the rear of the for not the front

[@TheBMWGuy]

I noticed that when I was editing and switched them around. Honest mistake

[@FucnutTurboRetardstrong]

What the hell is a gear clamp? Got one of these dont want to put in in the wrong way, im guessing your talking about the speedo cable??

[@carlh.schmidt1940]

Is it the same procedure on a R65 from 1979?

[@TheBMWGuy]

yes sir! All these videos are sponsored by you me, and the rest of us. If you are feeling generous please consider "joining" my channel, it cost as little as 1.99 and really helps me out. it will keep videos like this coming!

[@OnkelM]

If you have any questions about the BMW R60/6 engine, please learn German (sorry - a bad joke, I know...) and visit our old school lessions from the homeland of Bayrische Motorenwerke. kzbin.info/aero/PLsG3Iblabr3LskftyncfHMPmD-n1azDI3