Bobcat Drive Motor Troubleshooting using a Hydraulic Porta Power

Bobcat T590 has issues with both drive motors. We look at some troubleshooting tips to help with the repair.
shop.bobcat.com
www.4tetradgro...
Tools We Use:
Hydraulic Cylinder Spanner amzn.to/3SAlHYw
Another Spanner Option amzn.to/3LR1JFb
Hydraulic Seal Clasper www.4tetradgro...
Hydraulic Seal Stretcher www.4tetradgro...
Injector Block Off Cap www.4tetradgro...
Bobcat Fuel Filter Bowl Wrench www.4tetradgro...
Wrench Extender amzn.to/3Yt2yvl
Spring Compressor Tool amzn.to/4fA030n
Hydraulic Seal Installation Kit amzn.to/3Yrs6sV
Hand Impact Tool amzn.to/3Sz0yOk
Common Rail Fuel Injector Test Kit amzn.to/4dasD6T
Injector Leak Back Test Kit amzn.to/46Btf3i
Electrical Supplies:
Milwaukee Solder Iron amzn.to/4dpp0cY
Tesa Harness Tape amzn.to/3SAdG60
X Fasten Harness Tape amzn.to/4cbItNA
Non-Insulated Terminals amzn.to/4dp18XH
Short / Open Tester Power Probe amzn.to/3WRdrpu
Power Probe Master Kit amzn.to/3WPETUR
Shop Supplies:
Gloveworks Nitrile Gloves amzn.to/3WADdwW
Oil Absorbent Pads amzn.to/4ckYq48
Absorbent Pads amzn.to/3WOX64P
Brake Cleaner (Its Really Good) amzn.to/3yse3sA

[@crf50crazy]

Best guy to watch working on bobcat brand equipment on KZbin. Thank you sir!!

[@Asomesauc]

I really appreciate the quality of your videos. They have gotten much better. I'm glad you worked it out with Bobcat To be able to make these videos.

[@AlexPerez-gj7iu]

this is more entertaining than the playoffs thank you big dog!!!!!!

[@HidráulicaSincelejoIngenieria]

I have learned much more with your videos, keep it up I would like a video of the Bics valves in the S250

[@kylejohnson7464]

Thanks for your videos . They are always very informative . Looking forward to many . Keep up the great work .

[@karanveersingh899]

gave me such knowledgeable information. really appreciate you guys. I was looking for some information on drive motor these guys filled me in with that data

[@martincassidy4839]

On any hydrostatic pump. The slippers have groves in them for lubrication purposes, can not be lapped, plus you need to check the end float in the piston and the slippers, if lots of movement in slippers can cause massive failures. The lens plate can not be turned over it is one-sided only. The hydraulic functions have their own hydraulic pump and system .

[@jasonhulme3999]

Man, I bet you've trained many good techs!! You do a phenomenal job explaining it! I have a question - my T250 broke some of the 24 bolts on the back plate; the motors still worked good enough to load to take to my shop, of course leaking fluid while loading. I just topped it off to load quickly. Any idea what caused that to happen? Thanks

[@Stoparts]

Hello from Turkey/Istanbul colleagues. Nice job

[@CTSCAPER]

Could this damage have been avoided if the machine was taken out of service at the first hint of a problem, or perhaps at the end of the day or the next day?

[@jonrdahlin4390]

I just pulled a drive motor on a t650 yesterday. Brake seals blown out and pushing oil out of the of the hub seal.

[@jamalelmaskaouy2753]

Sir, I have questions about the Bobcat engine. I am a Bobcat driver. Please help me. The Bobcat engine is leaking oil. It is not from Lagog. Oil is coming out from under the engine..? Thank you

[@chrishall8142]

Should you get steam coming of a drive motor when you drive in a puddle .. I’ve got low power on all drive and lift functions .. and bucket drops fast with a load in it

[@jfitz9624]

They get pretty warm after running for a while so steam after getting them wet driving through a puddle isn’t unusual.

[@Somskalicious]

What if you don’t have any forward or any reverse? And if you use the stick it blinks the parking brake light at you.

[@wademizelle3433]

Great video. Thanks

[@ipxxx1]

Hi Please tell me where I can rebuild Drive Motors , Thank you !

[@TrexExcavating]

where is your shop? how much does a job like that cost?

[@christycarter75]

Hello great videos,can you tell me what size the caps are for the brake lines? Thanks

[@jacobsargent7627]

So I’m deployed over seas and there is a bobcat S130 here. Problem is the when you try and go forward and backward it will go maybe just a tad bit then bogs right out and dies.

[@kevinalexander2888]

Can you rotate the shaft of the drive motor to line up the mounting bolts?

[@Jimmysanders-k1v]

what is a normal operating temp on a drive motor i just got a t550 thx

[@irishcje1]

i got a bobcat t595 (tracks)that the parking brake is not engaging on the right side i still havent figured out why its not engaging

[@noeturrubiates5018]

how do you remove the small line next to the hydraulic hoses

[@nlambuca]

question iwth an ASV MD70. when I try to move, motor starts stalling, that tells me pump is ok and motor is ok, right? now I can't find the break details on that motor to check. Can you help?

[@SILICONVALLEY-hc6ei]

My skid steer s770 stuck going forward to the right as soon as I turn it on. Seems like its stuck on one side . I unplugged the electric joysticks but still goes forward as soon as I turn it on. Any idea what it could be ? Im not getting any codes either . Ty in advance.

[@firewoodsolutions]

I liked it first

[@tetradgroup]

Yes you did, that was quick!

[@jonb7470]

Great info. Ima cat dealer mechanic that works on larger stuff but I was trying to find a way to learn about the smaller stuff, and other brand stuff. This channel is a pleasant surprise.

[@BMRStudio]

30$ each….. for a clutch lamella 😂😂😂 Bobcat…. I wonder where You do hide all this profit in Your books! Teach me please 🙏

[@oursfort3024]

Please french traduction