Bostitch Nailer Repair - How to Replace the Rebuild Kit (Bostitch Part

Need help replacing the Rebuild Kit (Part #10250594) in your Bostitch Floor Stapler? Watch this how-to video with simple, step-by-step instructions for a successful DIY repair.
Don’t already have this part? You can pick up an authentic OEM part sourced directly from the original manufacturer here: www.fix.com/pa...
Fix Part Number: FIX10250594
OEM Part Number: 10250594
Why you might need to replace the Rebuild Kit:
1. Leaking Air
2. Will Not Fire
The information in this video is specific to Bostitch. To find a Rebuild Kit specific to your model, or to use our helpful model number locator, visit www.fix.com
Not what you’re looking for? For more Power Tool repair help click here: www.fix.com/pa...
For more helpful Nailer Repair videos, you can browse through the Power Tool Repair playlist on our KZbin channel: • Makita Angle Grinder R...
Fix.com is committed to providing you with high-quality parts, quickly and easily. Find out more about our fast shipping and interactive customer service on our website.
www.fix.com/
Stay safe during your repair! Be sure to check www.fix.com/sa... for proper safety procedures before you begin. Use of this video is at your own risk, without liability to Fix.com.
Connect With Us!
/ fixdotcom
/ fixdotcom
plus.google.co...
/ fix.com
If you found this video helpful, give us a thumbs-up, and subscribe to this channel for more useful repair videos! Don’t forget to leave us a question or comment below, and our customer service representatives will be happy to help!

[@JesusHernandez-pg9bg]

I just want to say thank you very much!! this video was key so that I could repair my gun correctly

[@163pete]

Your information was informative however, you left out some major pieces such as the bumper at the very bottom of the drive hammer! And whether or not, you should lubricate any of the parts going back in.

[@Mike-en5le]

Looks like you tweaked the procedure V.S. the driver install video. Is it the same model? Nice work.

[@johnkrasowski7733]

Hello..my nailer will fire once then go thud..then fire then go thud..what is the cause for this?? Thank you for your help..

[@jiggidyjam]

Where can I get the cap o ring?

[@johnkrasowski7733]

Hello. where can I order a new poppet o ring..seal?

[@sksam5984]

Good video,where I can get repair kits,thx

[@MrSmackdab]

that stapler looks like my dewalt - are they interchangeable ?

[@alegkourliak549]

Thank you very much!!!

[@CaraMelo-yv2to]

You forgot how lubricant whe you installed

[@gremlin230585]

it looks good but you forgot to put on one gasket