Bp automotive wiring harness installed on LS swap squarebody Chevy part 1

[@Chach1911]

Cant wait to see part too im literally in the same stage of my swap 85 k10 5.3, i got my harness all hooked up ik just trying to figure out where to get 12v/ign i have the same BP harness. Good luck brotha!

[@205_bowties]

Thank you, my truck is running and driving now.

[@TexasNova]

What did you do to fill the hole where you pulled the Wires through?

[@205_bowties]

The harness already had a rubber grommet that fit the hole. I think it was. 1 1/2”

[@squarebodybuilder]

I'm doing a similar build on my channel. Just fired my truck up.

[@205_bowties]

Nice man, looking forward to checking it out.

[@MarkPope-q3e]

Is it a mistake to buy a cheap harness,

[@205_bowties]

@@MarkPope-q3e I can’t answer that boss. I know a lot of people with cheap eBay/amazon harness that have no issues. Buy once cry once is what my dad always said.

[@Hotrodding]

Nice build! Is there no connection needed at the shifter on the transmission?

[@205_bowties]

@@Hotrodding I was able to use my factor th400 shift linkage. Since I went with the 4l80e it bolted right up. I planned to use lokar if that didn’t work.

[@Hotrodding]

@@205_bowties sorry I meant for the safety neutral.

[@205_bowties]

@@Hotrodding not totally needed, on a squarebody it’s built into the column. You can still use it if you want. The harness I have doesn’t have a plug for one.

[@Hotrodding]

@@205_bowties ok thanks , I noticed my harness doesn’t have it either.

[@playboishaq497]

Nice any update ?

[@205_bowties]

I’m working on a video of pinning out the squarebody bulkhead. Wiring the harness to truck

[@nadaa3589]

dose anyone know from where can i buy the 6.0 / 4L80E LS Swap GM 0411 PCM ECM

[@205_bowties]

@@nadaa3589 give BP Automotive a call/email