Thanks for your explanation, but I wish that the transmission of the crown could help me to have more force to climb rocks stronger better for my 2 speed transmission for an alxial SCX 10 2 1/10 Rc and a pinion for a 550 35T engine
@HarleyDesignsInc11 жыл бұрын
Absolutely. However on something like a Wraith (longer wheelbase) it will he more forgiving. In stock form a Wraith sits much too high and you could run into driveshaft angle issues. However my setup is lower and should have no issues.
@forrestcrabbe2 жыл бұрын
🤘🍻🤘
@HarleyDesignsInc11 жыл бұрын
I have heard the SCX gears are good (not the XR), this is my first time with them. I have also ran their lockers in the past and had good luck as well.
@rogerbeam33645 жыл бұрын
Does the Wraith & Yeti use the same transmission/transfere case ?
@HarleyDesignsInc5 жыл бұрын
No, they don’t use any of the same components in the transmission.
@rogerbeam33645 жыл бұрын
@@HarleyDesignsInc , ok Thank you , wanting too upgrade the gears in my yeti's transmission & transfere case , upgraded spur/pinion for speed and have overdrive bevel gears on the way , any suggestions for upgrading trans/transfere case gears ?
@HarleyDesignsInc11 жыл бұрын
Are you using the one piece Robinson Wraith gear? I have not ran that piece myself because I was always worried about when one part failing the whole piece was junk. I wish I had a better answer for you, but I would suggest getting a new final gear and going with a stock Axial output for now. Then maybe going to something like I show in this video down the road.
@jasonbrunda79577 жыл бұрын
if I use the super shafty long outdrive can it help with a front steel driveshaft that is a tiny bit short like a few millimeters short it looks like it would
@jasonbrunda79577 жыл бұрын
I also have the super shafty motor plate and vp trans with ssd metal gears and love it
@TrailAddict.11 жыл бұрын
What problems did you have with hot racing products?
@BlvlWmpower4 жыл бұрын
i remember they had a lot of fit and finish problems, even back over 5 years time when I was modding the 1st gen mini z. it's all chinese-sourced materials - i'm almost positive.
@TheRCNetwork11 жыл бұрын
Wow! Great information. I may build this up for my scx10 2.2
@CrawlerTedsGarage11 жыл бұрын
Nice job , Good info .
@lf2nd7055 жыл бұрын
Thanks man
@Peaceondastreetssan11 жыл бұрын
Thumbs up
@HarleyDesignsInc11 жыл бұрын
Blew up their XR gears, loose bearing tolerance in MRC knuckles, low grade aluminum causing stripped screws in several parts, poor design of pressed brass inserts in link ends... etc. In general I have never been impressed.
@acgkplh7 жыл бұрын
WTF! This is like listening to Japanese to a noob. I Just bought a 2nd hand Wraith.
@HarleyDesignsInc7 жыл бұрын
+acgkplh this was one of my early videos. I hate going back and listening to them, it drives me nuts.