Build DLG Glider Tail Vacuum Bagging - Half Molding Horizontal and Vertical Stabilizer

[@ОлегКо-э9к]

он смолу потом в чай добавлял ? А лимон где ? Почему деталь стала черной из прозрачного стекловолокна ?

[@michaelwhinnery164]

This made no sense at all, you laminated the mylar to the foam then discard the fiberglass ??? What ? I think you're supposed to fiberglass the foam using the mylars on the outside to achieve a smooth finish you did this inside out. What good did the fiberglass do if you just remove it ?

[@whatsgoingoncanada]

You should always wear gloves when handling a poxy resin.

[@nepaero]

Okay ... Next build i will used it

[@whatsgoingoncanada]

Your work is amazing. Thanks for sharing

[@thecrafter4316]

@@nepaero lhoo ya...kandani og. Samean nggae sarung tangan karet nitril

[@thecrafter4316]

@@nepaero aku biasane sarung tangan iku tak gae bola-bali, tur yo kenek diwalik. Tak kirimi sisan klambine aa?? Tapi samean sing bayar ongkir e yoo? Aku lagi bunces iki...wkwkwk

[@nepaero]

@@thecrafter4316 siappp ...