Building RatRig V-Core-4 IDEX 3D Printer: Part 4 - Installing Belts and Build plate

[@BackwoodsTinkerer]

You're not alone. Hopefully Cruz adds some clarification in the documentation. I highly suggest checking the comments on any step that have any before performing that step. Lots of helpful feedback from other users

[@hedleypepper1838]

Please continue your videos as you use the printer..... good job 😊

[@thebrigandier]

Thanks for the guide. Having some familiarity with the machine is going to be huge during the build process.

[@RocketkidDesigns]

Happy to help, I'm really glad I might be able to make your build go smoother.

[@antonbuharin]

For the belt routing: If you have another printer then instead of zip tie print a 200x9x0.4mm stripe, so much easier to route. Got it from Mandic labs

[@RocketkidDesigns]

That sounds like a great tip!

[@theolivegrove342]

I had to pause the video. I'm half way through and I'm sitting here fully absorbed in the material. I keep thinking 'I wish more of my college professors taught/delivered information like you do. I might have enjoyed the courses more. Thanks for another quality video. Did your other printer show up? Are you going to make a video on it also?

[@theolivegrove342]

"Patience waning"🤣😆 Thanks for humanizing the build process.

[@Rmilyard]

When doing next video?

[@RocketkidDesigns]

Working on it now probably will be one or two days still. Work has been super busy so I got behind on the videos.

[@DarkangaelBrokenwing]

Thank you was looking into building a printer. Did you like the result?

[@RocketkidDesigns]

I do, I've been using it quite a bit lately.

[@kazolar]

I hope that bed is flat, the bed plate seemed kinda wobbly, unless your worktable is less than flat

[@RocketkidDesigns]

Yeah I was concerned for a second but the bed was perfectly flat I think there was a piece of wire insulation or something that was under it that I didn't notice at the time.

[@Rmilyard]

OMG this is a nightmare!

[@AshleyLiu-h9g]

wanna have a collaboration