Building The Drift 1 Go Kart part 1

[@markgonzalez4070]

Looks killer!!! Can’t wait to see the finished product

[@walkerfablab]

Thank you for that comment! We greatly appreciate you telling us! We will be sure to keep you posted then!!

[@stanlucas665]

Just found your channel. The kart looks great

[@walkerfablab]

Dude!! We appreciate the comment!!! Like big time!!! Anything you would like us to do explain or see built? You ask we shall try to do it!!

[@stanlucas665]

@@walkerfablab I’m new to your channel but I’d really like to see you put a center support bearing on the rear axle. I know most people say it doesn’t need it, but I’ve seen plenty of drift trikes that have bent axles because they have no center support. I have a mini drag trike with a narrow axle. If it were a wide track I would definitely add another bearing somehow. Again, just my opinion I prefer longevity over performance in a build like this. Are you going to put out a you weld it kit?

[@walkerfablab]

⁠@@stanlucas665yes that’s the plan! And we don’t have problems with deflection because the sprocket is close to the pillow block bearing. Hence why most motors are offset. You can get about 1/4” of deflection out of a shaft if driven from the center. These are built to last! 38-40” axle is recommended no wider or you will end up bend shafts more often. They are only 1’ shafts.

[@fareed006]

Looks great. Can't wait to see the final result!

[@walkerfablab]

Thank you for the comment! We will be sure to keep you posted on the builds! Currently waiting on parts!