Bully Side Step Installation 2014 Chevy Silverado

In this video I install Bully Brand side steps on a 2014 Chevy Silverado crew cab. I install 4 steps and show what tools I used.
Disclaimer:
Due to factors beyond the control of Mike's World, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. Mike's World assumes no liability for property damage or injury incurred as a result of any of the information contained in these videos.

[@frankherring6253]

6.2k views; it seems you are the only person to put these on a 2014 Chevy. Thanks!

[@mikesworld60]

Your Welcome!

[@BOOT]

Good tip on the combination square. Only needed one step on the pass side for my mother, so found a single cheap on ebay w/o hardware. Got better self tapping screws & grade 5 bolts at my local Ace anyway.

[@SkylarHillShop]

Boy those rockers are in good shape! My 2013 Expedition has some large holes where the rockers should be. It has the powered running boards which are great at holding mud and all that winter junk nice and tight to the body...

[@mikesworld60]

I understand they use a lot of salt on the roads in some states. I live in western Washington, and they use salt, but we don't get that much weather that requires it, so our vehicles don't rust out bad. Now in Seattle which is still western Washington they use a lot more. I don't live near Seattle. I am in a rural area west of Seattle towards the Olympic mountains.

[@davidwebster8135]

You have over 2000 views! This helped me. Thanks

[@mikesworld60]

You're welcome!

[@SpennyThaKid]

IT'S A ROBERTSON!!!!!!!!!! not a square drive. Otherwise great video. Really helped me out!

[@mikesworld60]

Glad it helps you out! But I will still say square drive.

[@therifty1]

Thank you!

[@mikesworld60]

You're welcome!

[@CA10Z]

Hopefully my 1974 Short bed C10 will have good welds...thanks for the video Reply

[@mikesworld60]

I hope so, good luck

[@cinelli07]

Did you install the steps? I've got a 73 k20 I want to do the same

[@vinnygoombatts1458]

So there's no pre-drilled holes you have to measure it and just put it where you want?

[@mikesworld60]

That's what I did, the instructions give you an idea where to put them. There were no predrilled holes in this truck.