A1.2714 This set is based on the original tool to remove wheel hubs. With the supplied attachments the tool can also be used for the (dis) assembly of the wheel bearings on the front and rear of the 2CV.
Пікірлер: 12
@georgeturnbull81763 жыл бұрын
Why not clean all the area around the bearing housing before fitting new bearing? Very poor engineering.
@hermannjahn5421 Жыл бұрын
Waarom de boring van 4 mm ?
@2CVCult-zl8eo Жыл бұрын
What is the reason for drilling two holes of 4mm x 3mm deep into the retention ring?
@shanedebarra4986 Жыл бұрын
They are drilling through previous peening points ... (places where the the ring has been chiseled in past) ... if you don't drill the previous peening out and you try to remove the ring it will either be difficult to turn or damage the threads when coming out (or both) Hope that helps.
@dutchcitroen2cv4 жыл бұрын
persoonlijk zou ik het lagerhuis eerst flink schoonmaken zolang het oude lager er nog in zit ...en het borgplaatje vervangen van de stuur as. (welke niet geborgd is)
@sjoerdengeltjes16414 жыл бұрын
Het stuurkogelarmpje is idd niet geborgd, maar ik denk dat deze niet vervangen wordt omdat ze in een andere video laten zien hoe de fuseepen vervangen wordt. moet anders dubbel vervangen worden.
@basdevries81054 жыл бұрын
Zou je het niet even schoonmaken wat een gepruts zo ben je echt aan het beunen