Bushwacker Cut Out Fender Flare Installation by Mark Polk

[@rveducation101]

@ tlgrimmy, I actually installed the Napier Precision hood vents on my sons truck and they seem like a good product, but I have never used their fender flares. I really like the Bushwacker fender flares and had no issues with the installation.

[@jzmun]

good job man. i liked the detailed instructions and that will help me put on mine.

[@CheapGeek]

Great Video! I like all of them, actually! Good Looking Truck too! I would have loved something like that for my first vehicle. Thanks..

[@rogerwatson5691]

Thanks for the video, very detailed, any chance you know the cut measurements for a 1999 Jeep Cherokee xj?

[@rveducation101]

Thank-you! We appreciate the comments!

[@Jredding352]

I would love to have a truck that nice for my first vehicle

[@Guayabaman305]

that looks beautiful

[@rveducation101]

Thank-you! Actually I was surprised they made them for the Comanche.

[@John_BP]

Can you get a fender like this for a Toyota 89 dlx that doesn't involve cutting i'm trying to cover up dents on the fender not put bogging tires on my truck.

[@tlgrimmy]

Thanks for the great video! I was curious if you looked at the Napier Precision flares in your research. I've been looking at both the Bushwacker and Napier products and thought I'd ask if you like one better than the other. Thanks!

[@shawnalexander1158]

i have a 98 2 door tahoe with 3 inch lift but my baja tires are rubbing on top of finder when i hit bumps or pull into elevated drive way, i assume you can cut away a little of the top of finder as well. Any tips on this?

[@John_BP]

I checked out the sight and went threw a few forums it looks like ill only have to cut if i wanted to go over 35x10.5x15. It already has a 3 inch body lift so i don't think clearance will be an issue. I'm going to check with a mechanic first tho.

[@MatthewMello]

Great video Mark. I would LOVE to install these on my Jeep Liberty Diesel after I upgrade to another Tow Vehicle, but they don't make them for it. Oh well.

[@creade3783]

How come you dont mention any thing about removing inner fender-well or welding a support brace in place?

[@Gumbie2009]

would think you would want to drill before paint so you can seal it. way you did it will encourage rust

[@titan371]

Nice job look great

[@Fkidd702]

Nice

[@thefablab4857]

guys id recomend putting masking tape down before you drill the holes so the paint down chip

[@garrettlamb9916]

I would have definitely lifted that truck before cutting the fenders off of it!

[@zakkwylde4201]

Badass

[@rveducation101]

I'm not sure, but you can go to bushwacker(dot)com and see what they offer.

[@trumpwon20204]

Ouch. Do not use a sawzall or jigsaw.... use a cut disc....