Installing cam bolts, plates and alignment pins in my 2003 gmc 2500hd
Пікірлер: 14
@barajas2k44 ай бұрын
Glad I found your video. Your way of getting those pins in looks way easier than what I was doing. On my way right now to get 2” bolt. Thanks for the video
@ryanwilliams72243 ай бұрын
Came here for Pin install. Great idea with the nut and bolt setup!
@christianv49513 күн бұрын
How are they holding up?? Thinking of buying these
@OnTheToolsWithSal2 ай бұрын
Excellent video
@Army_Retired Жыл бұрын
Thanks for sharing
@dalemihocik4732 Жыл бұрын
Interesting that you replaced the kit that was already on the truck as it had the positive stops and replaced those with the open slotted type. Most guys are doing the opposite of what you did and going to the positive stop kits.
@Cruff16 Жыл бұрын
The ones that I had where round hold for the bolt, the bolt could rotate inside pulling the truck out of alignment. The good ones have a flat side on the hole to match the bolt so it doesn’t rotate on its own. This is what the local shop sold so I grabbed them
@itsmemaaaark Жыл бұрын
I had those kryptonite ones on for about a year until I went over to the Dirt King locking alignment cams. Much better and alignment finally stays in place. My truck is not a street truck and gets driven hard offroad living in the desert.
@taylorshiver3284 Жыл бұрын
Where is the alignment video?
@deanfitzsimmons2704 ай бұрын
Did you ever make an alignment video?
@Cruff164 ай бұрын
I never did, ran out of time and got busy with work sorry
@SlsNetwork Жыл бұрын
What vehicle is this
@Cruff16 Жыл бұрын
2003 gmc sierra 2500
@jarodmorris4408 Жыл бұрын
I don't think I have a bolt that would fit so perfectly. I'm about to smack them with an air hammer. Hope I don't regret it.