I cannot get my back spring to move a millimeter. And suggestions? I’ve tried WD40 but still nothing. Currently using a spanner wrench.
@gigi19mai12 жыл бұрын
Lift the bike to release the tension in the spring
@joncherokee2 жыл бұрын
You must weigh 100lbs if you want it that soft. Obviously you don't fear bottoming out in the rear.
@DFWM-C3 жыл бұрын
I didn’t know you could lower the rally
@egibs35653 жыл бұрын
You can tighten the 600 Ryker spring too, stiff ride but stable 🤷🏾♂️
@kip15123 жыл бұрын
Why?
@gigi19mai13 жыл бұрын
Pros: Lower center of gravity, increased stability, better cornering, less counter steering, higher G forces. Cons: Reduced ride comfort on bumpy roads.
@jamesglenn5203 жыл бұрын
Why would you use WD-40? It is not a lubricant at all it's a Water Displacement solvent. WD=Water Displacement
@gigi19mai13 жыл бұрын
Provides a bit of lubrication, yet without leaving grease behind, as it's drying. Oil lubricant and grease will remain, trap dirt and might allow for movement in these part, which you don't want.
@ricklove1613 Жыл бұрын
What size is the wrench
@bitterbitterbitter Жыл бұрын
you just got schooled ;)
@Rev_1776_Ай бұрын
He's using it bc it works for his immediate need, duh, lol. Simple.