Can Am X3 Waste Gate Adjustment

[@MONTANA-bg8qh]

Bro i bend the flapper valve and broke off the peg🤦🏽🤦🏽 i straight it as much as i could but cant put the lil peg. Also does the flapper valve supposed to be loose? Wiggles left to right like of its loose. Did i just mest up my turbo??

[@aftermarketassassins5491]

No good to hear! The flapper valve should move freely back/forth with the wastegate actuator rod disconnected.

[@MONTANA-bg8qh]

@@aftermarketassassins5491 flapper valve does move freely i wasn’t sure if it had to have tension. I thought it did so looks like im good on that then. Thanks i just need to figure out how to put that lil nipple back on the flapper valve thanks i wish i would of seen your video first you explain the process perfectly👍🏼👍🏼👍🏼 thanks 🙏🏽

[@lalo_etz]

i broke the peg🙄 any advice ? weld ? screw and nut?

[@aftermarketassassins5491]

No good! We've not had this happen, so no direct experience.... but in other applications we use a shoulder bolt. Welding an new peg on would also work... if you can get to the back side.

[@Dannymexx]

How high it can go the oem

[@aftermarketassassins5491]

10-12psi is about as far as we like to go as the throw is also being shortened.

[@dont4getatowel]

I’m thinking about purchasing the powervision 3 for my can am maverick x3 turbo rr loaded with the stage 2 tune from you guys off of Rpmpowersports it says to shorten the waste gate rod 2 turns from the stock position for the stage 2 tune so that is 2 complete turns? I run a ggb race exhaust and a rpm blow off valve and wanted to see if this tune is fine for my machine I normally use 93 octane pump gas.

[@aftermarketassassins5491]

Great to hear! Yes 2 full revolutions shorter is what you want. That tune will run great with your setup on the 93 octane fuel, they rip!

[@reneulloa2437]

How many turns on a stage 3 if you go shorter is that adding pressure? And is it better doing it like that than using the pressure pump gun that ive seen they use

[@el24najera]

How many turns for 1 psi

[@aftermarketassassins5491]

Roughly 1 turn for 1 psi

[@marcogalaviz5574]

@@aftermarketassassins5491 so if it’s at 7 and I need 8 I go 1 Turn shorter or 1 turn longer?

[@aftermarketassassins5491]

@@marcogalaviz5574 1 turn shorter would bring the PSI up

[@pedromata9482]

I have a 18 172hp an tuned to 205hp what's the waistgate need to be?

[@reneulloa2437]

Is that set at 8psi on this video??

[@LOOKFAST]

You went 1 and a half