Case 580K Extendahoe Removal

[@garyhopkinssr8561]

Right on man this was helpful I can't wait to see how you put the thumb on their thank you for the video.✌

[@topscottfuel]

Very helpful NineCarG, thanks!

[@darrelldohrwardt7754]

Great video, I’m still trying to my 2.5 rod by 3.5 cylinder dipper piston nut off. I got the seal kits for entire boom, just trying not beat up my chrome or fingers! Don’t forget the hoses!!

[@NineCarGarage]

The hoses are the worst and very expensive. If I was braver, or had a swagger, I'd make them myself. About that bolt, add heat!

[@Trumpistoast2024]

Thanks for the tips!

[@krisv8407]

Good stuff bud

[@Eddlemon08]

Where did you get the manual thumb from? I’m needing one. Thanks

[@NineCarGarage]

Titan attachments. See my other video for more info!

[@labla8940]

Do you have a section where the extenda hoe retraction hose (bottom hose xtendahoe) from valve body how its routed? I had someone remove it and cant figure correct routing

[@NineCarGarage]

I have the workshop manual and can take a video of the route if you still need it

[@labla8940]

@@NineCarGarage hank you that's generous I think I routed. it wore out originally at the coupled end at the 90 coupler I think it was replaced before and installed wrong as it wore down through at that spot. I have 1000+ page manual but its more for rebuild and has exploded view Its PDF on my PC. I couldnt figure it out there I am not even sure I am reading it correctly. If its not to much trouble I would appreciate that