No excavator is Safe! Fast and Easy Pin/Bushing Swap

Рет қаралды 15,239

Күн бұрын

Пікірлер: 14

@tedsshed2185 2 күн бұрын

Great Video A little trick to make life even easier fitting the bucket put you tipping link into the bucket first put a smaller bar through the the pin hole then pick the bucket up and dangle the bucket to fit the main pin crowd the bucket and then fit the tipping link pin? Cheers Steve over the pond

@ericbrinson9741 28 күн бұрын

Thanks for sharing, looks like you’ve refined your process to be efficient, I like that. It took you 2 hours it woulda taken me 2 days lol

@denjhill 7 күн бұрын

Would have liked to see how you inserted the pins. On my backhoe it has been a problem taking a couple of days when working alone.

@ShadeTree_Certified 4 күн бұрын

I grab an angle finder, check what the machine is at, then try to get the bucket as close to the angle of the machine as possible so the pin goes in smooth. Sometimes I can push them in by hand. This one required a couple taps with the sledge.

@heavymachinery2843 Ай бұрын

Nice job

@ggcutter4098 Ай бұрын

try using a straight torch head with a scarfing tip it works really well

@ShadeTree_Certified 24 күн бұрын

I use a straight tip, just a 90* torch head. The gouging tip doesn’t work very well for me

@lonex00 6 күн бұрын

I came to see how the pin goes in. Just smack the pin I guess. I sheared a pin off I have the replacement pin and have it started on the one end and was going to bash it in and push the old pin out at the same time. I don’t have a hydraulic press so time for muscle.

@kentuckyshiner 16 күн бұрын

What pump and jack are you using?

@ShadeTree_Certified 15 күн бұрын

Bra air over hydraulic foot pump and an eagle pro 30 ton hollow single acting ram. Have had this setup about 8 years and I haven’t had a bushing that I couldn’t pull within reason