Casting buckshot

[@hachmiwahab7515]

Hello, how much do I put a # 000 buck shot in the cartridge of 12 caliber and two thanks

[@antomanelven]

9 balls

[@ReichenbachEsq]

Do you have time to make & post a video that shows how to properly soot the mold?

[@MsPastor777]

Nice video, thank you very much. I have a question that is probably very simplistic, but being new to casting, I have to ask it, and it is this: I just received my Lee bullet mold handles for the 6 cavity mold. Before I even go to casting, I was trying out the handles on the mold and I see that the handle has no way of "staying in place", adhered or holding the mold. When I open the mold, the handles tend to "come off". I don't see that happening when you are casting. My question is: Is it the heat that keeps the handles adhered to the mold? Have you ever had the mold "fall" from the handles? Excuse my ignorance, but as I said, I am new to casting and want to find out if this is "normal", or what? Thank you very much for your answer. Be safe and be blessed.

[@hottrodscars]

The sprue opener handle tends to want to come off now and then, helps to just shim it up with some fine slivers of wood or thin wood shavings. Or you could try a fuel line clamp around the wood handle to hold it tighter,

[@Mav8887.]

hard to get that last ball, i finally got it to a t. good video

[@lawrence1md]

Ummm