Caterpillar 973C

[@user-tr4op2fm7v]

always put truck near and angle it so you do not turn loader...save alot of $$$ on rollers pins and tracks etc.

[@stevereese9874]

tip, when your going into the pile raise the arms a hint to put down pressure on tracks and get a more full bucket.. i know bc iv been doing it for over 38 years

[@davidwillard7334]

I was Told , if you Lift the Arms ! Then your Damaging you lift Hydraulics !! Just Roll the Bucket back ! And Creep it Forward ! Then back out !

[@franksweets1859]

Sehr schönes Video, sehr schöner Maschinensound, danke!

[@markadams7235]

Recall a 963 being dropped into the bottom of a coal ship at Liverpool docks from crane many years ago, track balance bar and loading frame were bent, but repaired and went back into service, tough machines.

[@Hynekzakpeccosk400]

Dobré video, to se to těží stavební jáma s takovou mechanizací.

[@balmesh]

Good video - that driver knows his job!

[@marekdirgas3607]

Pásový caterpillar je moc pekný stroj

[@rogerwoodland2587]

very good operator.

[@davidwillard7334]

Next Time ! Get an Excavator !! And at least a minimum Three Trucks !

[@stevereese9874]

why so far?? your should be able to load right after you take a scoop.. if anything he is way to far away!!

[@mefistofeles666111]

Luxus! A kde jsi to točil, není-li to tajné? :-D

[@jameslindley8318]

977L is just as fast !! 973 might gain a bit due to counter rotation

[@mrtom2C]

Je to točené u Bohunické nemocnice v Brně ;) Pecco jo to maš pravdu šlo to jak po másle

[@LLImprovement]

To get a ripper and the third valve on my machine would cost me $20,000 i dont have haha

[@CarlosGarcia-vl2mq]

Les falta un votaso son3 y debes aser mas boteo para que no patines mucho las cadenas te lo dise un sobrestante

[@jimmydickson8854]

And bring the truck closer too save fuel

[@Amanwithoutaface112]

only 2 scoops? those trucks can hold more then that, load em up

[@DieselandIron]

+Skankpronger If they are hauling offsite they are probably worried about weight restrictions.

[@scotabot7826]

So inefficient!!!!! These guys wouldn't work for me. That's for sure, unless they were paying for their own undercarriage!!! So darn wasteful!!!!

[@18chara05]

pekny caterpillar aj video len nech sluzi ten stroj videt ze strojnik znim naraba ako sa slusi a patri a ne ako poniektori co videl nestaraju oto o taky stroj sa treba starat

[@magjag1669]

I really dislike this style track loader...I like the old design. The cat 983

[@taylorl5259]

try getting a full bucket next time.

[@rogerwoodland2587]

getting a full bucket is what he is good at.

[@mojostevo]

He can fill a bucket, I'll give him that, but park the truck closer.

[@jameslindley8318]

DRIVERS NAME MUST BE ARFUR BUCKET

[@davidwillard7334]

Could you have got more in !?

[@dozerman8114]

Park the truck farther away..

[@jameslindley8318]

Dumb ass !! lol

[@rogerwoodland2587]

park the truck closer.

[@jameslindley8318]

I LIKE TRACK WEAR ! i LIKE TRACK WEAR I LIKE TRACK COZ I AINT PAYING FOR EM !!!!!!!

[@jameslindley8318]

barry beatty not yelling bud ! Just caps

[@davidwillard7334]

Bad ! Enough ! With Rubber ! TYRE !! WEAR ! On Wheel Loader / BOBCAT !

[@7892rl]

is this loader operator getting paid by the mile ??

[@paulcoote3094]

How NOT to operate a drott.

[@user-tr4op2fm7v]

977 strong but slow

[@taylorl5259]

fucking waste of a 973.

[@chiaki962006]

下手くそ　　なぜダンプの方を前後させない？？　　効率悪すぎだろただでさえ遅いのに