5x CAT 631G and a pusher D10T working at a site in germany.
Пікірлер: 16
@neftalirosado61675 жыл бұрын
Wonderful video and perfect close up. Good job 👏
@LaderfahrerZL40016 жыл бұрын
Da steckt Power dahinter. Klasse Video.
@Schlorg6 жыл бұрын
Die bringen was weiter! Mein Baustellenhighlight 2018... Saugeiles Video, Tom! :-)
@christopheroupioz79386 жыл бұрын
super video!merçi!
@callmewheels48064 жыл бұрын
Now there’s a first for me. I have NEVER seen Sand ripped. These operators might benefit from a little schooling in Optimizing a 631 and D10 pushcat. Watch a little KZbin action in Southern California where scraper-shows are a common theme. A scraper shouldn’t have to wait for the crawler nor should the pushcat continue pushing once the apron is dropped. Pretty friendly material to work in though. Nice video’s as well.
@lewiemcneely9143 Жыл бұрын
It is strange. Ought to catch the pan on the fly too. No use stopping.
@dennisholst43222 ай бұрын
Can't be that tough
@Fonkeymish016 жыл бұрын
Changing direction at full throttle?
@christopheroupioz79386 жыл бұрын
where is it?
@chriscardoza97146 жыл бұрын
I know it's all about speed .
@briangardiner10156 жыл бұрын
I would like to see more companies in Europe adopt the Push-Pull scrapers. Would eliminate the push Cat.
@scottcorwin36146 жыл бұрын
not the most efficient way imo , mass excavators and haul trucks much easier on equipment than what that dozer is getting done to itself
@Gocha-Catsewen5 жыл бұрын
kzbin.info/www/bejne/qaLYeJ-resycjZY
@Gavin84w3 жыл бұрын
@@scottcorwin3614 complete rubbish, expensive dirt if scrapers can do it and you chose excavators and trucks
@dennisholst43222 ай бұрын
Mongul is there
@Gavin84w4 жыл бұрын
Not sure why you would have a single shank ripper on a push tractor, clearly a multishank ripper is the best option, complete 50% more ripping for the scrapers each pass