Causes and Fixes P0010 Code: “A” Camshaft Position Actuator Circuit / Open (Bank 1)

[@erwinsm10]

Same code on my Scion Xa drove me nuts ! Not caused by any of these mentioned , it was one bad ignition coil that only failed when hot . it Fixed the code resolved . no misfire code .

[@PatT-wg2gl]

2019 Hyundai Santa Fe limited. Codes P0010, P0011 thrown. Put a new solenoid sensor on it and the check engine light went off and then came right back on a couple minutes later. Noticed the oil was super dirty and 2 quarts low after we had taken it to the dealership for an oil change that we believe now was never done. Car has over 200,000 miles on it and we’ve never had any problems and we are always on schedule with oil changes and such. Got the oil changed today and the check engine light was off. Drove it about 15 minutes and the check engine light came back on. Scanned it and the P0010 code shown… Engine bank 1, so just checking to see how we replace what may be the actuator in this case. Thank you

[@joeybalogny6095]

great video I like the detail thanks

[@forpilo]

I have a P2C0F - A Camshaft Profile Actuator Position Sensor C Circuit Low Bank 1. It’s on a 2020 L3B Silverado

[@wackoJacko-dg9ny]

My Pontiac Solstice shows this error, replaced the intake VVT solenoid and the connector, not sure what else can I do

[@viralgandhi]

Hi, I have similar error code - "A" Camshaft Position Actuator Circuit (Bank 1) on 2015 Hyundai sonata . I just did oil change but engine light didn't go off. I see rpm is hovering around 1000-1200 when car is parked and started. Do you think I need to change VVT solenoid?

[@M.Alvarado-st2ze]

Thank you that really helped

[@cristalrodriguez9733]

What would a mechanic charge if you fixed all the sensors and it's still showing that code?

[@AllenWest-i8p]

Hey will that p0010 cause my truck not to start because it's not pressuring the fuel rail it's a 2011 GMC 2500 6.0 gas hd 4 door 2wd if you need more info let me know because it has not ran in 3 yrs I bought it and barely put 10000 miles on it but there is a story

[@dominiquestansell314]

IF MY ENGINE LIGHT STILL ON AFTER CHANGING THE COVER AND THE VALVE WHAT SHOULD I DO???

[@FlyinGuy25]

I changed the cam position sensors ($44 total for both), and that cleared my engine check light

[@dominiquestansell314]

@FlyinGuy25 DID it run the same? Are did it start running better 🤔

[@FlyinGuy25]

@@dominiquestansell314 Yes, the idle got way better, but I am now working on changing the two VVT solenoids as the timing is still off.

[@mrcluchh7223]

@@FlyinGuy25did changing the vvt help it??

[@FlyinGuy25]

@@mrcluchh7223 Haven’t finished yet. Got 1 to go. Getting the passenger side valve cover off was not easy.

[@danielmoore7027]

Thanks

[@BryanG830]

My car had code but before I can even fix the issue, the code disappeared by itself and never came back.

[@ronaldppdurham5368]

P0013 code