Centurion D6 Smart sliding gate motor installation in Montclare Johannesburg by Pottie 083 778 2288

Centurion D6 Smart sliding gate motor installation in Montclare Johannesburg by Pottie 083 778 2288.
Pottie from Exquisite Security is well known in the Centurion sliding gate motor market.
With 20 years experience in the installations of all makes of gate motors, it is clear, that Pottie has seen and done it all.
Still, Pottie does all installations himself along with Amanda his wife. No short cuts are taken as we are proud of our work.
Amanda can be contacted on 083 719 2250.
The knowledge Pottie has, with Centurion sliding gate motors is huge.
Pottie, is one installer who can and will repair/ service/ maintain any gate motor on site. There is no need, to remove a gate motor from site as all is done, on site. This includes, all models of Centurion sliding gate motors, Gemini sliding gate motors as well as the DTS range of sliding gate motors.
The reason is that the listed gate motors above, parts are easily sourced.
Pottie can do all of this on site, he has the knowledge and that is the reason, why you should call Pottie today to assist with your sliding gate motor system.
Roger found Pottie on the web, and requested that Pottie perform a Centurion D6 Smart sliding gate motor installation for him.
This gate motor installation was conducted on 4 November 2024.
1st. The site was inspected, where and what was needed in order to perform the Centurion gate motor installation.
2nd. The concrete platform was cut open to allow the electrical cable to fit into the slot. A Slot was cut in the steel platform which allowed the electrical supply cable to fit through. The steel platform was then welded into position and secured down completely with the needed coach screws.
3rd. The Centurion Smart gate motor steel base plate was fitted with the generic anti theft bracket ears. The ears were welded down into position.
4th. The complete gate motor system was then test fitted into position, which allowed for the gate motor steel base plate to be spot welded into position.
5th. The gate motor specifications were checked and found to be right, this allowed one to weld the gate motor steel base plate down completely.
The gate motor was then secured with all of its supplied steel bolts.
6th. The steel rack was then welded into position, according to factory specifications. The steel rack was also supported with steel brackets on the ends.
7th. The gate motor electrical wires were then connected, the gate motor batteries were connected and double checked for correctness.
8th. The gate motor limits were set by using the Mycentsys pro app.
9th. The sentry infra red gate beams were fitted to the drive way gate system.
The gate beams were checked and found to be working properly.
10th. The client was informed, what to do, and how to do things via the Mycentsys app. The site was handed over to the client.
For more information, please look here regarding gate motor installations in Johannesburg:
www.exquisites...
for more information, look here:
www.exquisites...
Centurion D6 Smart sliding gate motors can run gates up to 600kg and up to 36 meters per minute.
That is very quick, for any steel sliding gate.
Centurion D6 Smart gate motors are programed via the Mycentsys pro app
All settings are made on the app, and transferred to the gate motor.
The Centurion D6 Smart sliding gate motor runs off 2x 12 volt lead acid batteries.
The steel platforms used by Pottie on which he mounts his gate motors are, 240mmx350mmx4mm thick steel plates.
These steel plates are very strong and one cannot rip the steel plates off and out the ground. The gate motors Pottie install are clearly safe from being stolen.
If you want a theft proof Centurion Smart gate motor installation, then you need to call Pottie today!!
be on the lookout for our new website which is being build.
www.smartgates...