Cforce 500 belt swap / maintenance

[@darrenmcquade215]

So Im assuming you use a clutch spreader to remove the belt, dont you have to adjust tension when new belt is installed? Dodnt see you use clutch spreader to re-tighten.

[@nolimit_tv5584]

Thank you for this vidoe

[@RexAuto1]

My pleasure, hope it helped!

[@marmarti231]

I wish I would have watched this before I broke the 18mm bolt. How do I remove that? I see a hex on the primary hub, is that Left hand thread also?

[@ferdidemir460]

What kind of impact driller is that? How many torques does it produce?

[@RexAuto1]

Its a milwaukee, who knows what kinda torque it produces. Just dont over tighten it 🤷‍♂️🤣

[@ferdidemir460]

@@RexAuto1 I tried to open the big nut (32mm) with my hands but I couldn't. So im curious about what kind of driller i need.

[@ferdidemir460]

400nm torques doesnt even work.

[@RexAuto1]

@ferdidemir460 what are you trying to do get it off? Itw reverse thread.. meaning righty loosey

[@ferdidemir460]

@@RexAuto1 i knew that. Thx anyway.

[@braydenmoore4326]

What’s the tool u used for loosening the belt?

[@RexAuto1]

It's a clutch spreader, main street cycle is where I got mine

[@iceman2520]

What direction does the one-way bearing spin free? Thanks

[@RexAuto1]

I believe it free spins counter clockwise

[@iceman2520]

@RexAuto1 that's what I was thinking but didn't pay attention before pulling it off thanks

[@jramos1173]

What is the name of that tool please

[@RexAuto1]

The secondary spreader? I guess thats what its called. Got mine from main street cycle, but just Google secondary clutch spreader.

[@johnboertmann9267]

@@RexAuto1 any m6 bolt about 3 inches long will work.

[@RockstarATVrentals]

30mm not a 32mm

[@Bland04]

Could be 30 or 32, depending on early production or later production. My 2021 400 has a 32.

[@donnyslays2819]

Not a 32