拆股、穿針_新手必學的刺繡知識Stock disassembly and needle

新手注意⚠️
A:輪廓繡繡著為什麼比教程中粗
Q:首先檢查一下股數是否有錯，比如兩股線為一股穿針對折，一股線為一股穿針不對折單 線繡。其次輪廓繡的針法每一針長度不能低於6MM，針腳越短越顯粗，另輪廓繡的下一針永遠都是從上一針的針眼裡挑出來，在底稿的直線上，如果是位置偏移到上或是下，就顯粗一倍。
A:我的線為什麼容易打結，容易斷?
Q:如為一股線刺繡，請務必將整根對半剪斷以後再抽股使用，繡線過長會長會造成頻繁打結哦。
A:繡著繡著為什麼會起皺？
Q:最大的可能是排線過密。
A:我的線感覺配的不太夠。
Q:配線已經按正常使用加倍配置，用線的多少直接決定繡面的美觀程度也會造成起皺變形問題 。
❌新手大忌❌
排線過密，隨著股數的多少每針的行間距要進行調整，讓線能平鋪於布而不擁擠。
太密會造成起皺，繡面不平，絲理混亂，「稀可補救，密無可救」
Novice Note ⚠ ️
A: Why is the contour embroidery thicker than in the tutorial?
Q: First, check whether the number of stocks is wrong. For example, the two lines are a target of a target, and a line is a stream of needle -piercing. Secondly, the length of each needle method of the sirling of the silhouette should not be less than 6mm. The shorter the pins, the thicker the thicker. The location of the position is twice as thick as top or down.
A: Why is my line easy to knot and break it easily?
Q: If it is an embroidery for a line, be sure to use the whole root to cut the shares and then use it. The long -term president of the embroidery line will cause frequent knots.
A: Why do you wrinkle with embroidery?
Q: The biggest possibility is that the line is too dense.
A: My line feels not enough.
Q: The wiring has been doubled according to the normal use. The amount of use of the line directly determines the aesthetics of the embroidery surface will also cause wrinkles deformation.
❌ Novice
The lines are too dense, and the spacing of each needle of the stock must be adjusted, so that the thread can be placed on the cloth without crowded.
Too dense will cause wrinkles, unexplained faces, chaotic, "rare can be remedied, unavoidable"

[@zekunyang7338]

谢谢博主！

[@user-vg3vh5xh1k]

💖💖💖😍😍😍

[@gigilin5197]

請問為什麼線撮開，又把兩條併在一起穿針

[@user-cm5zg9ow1l]

您好 想請問五股 ，六股也都是一樣方法嗎？

[@gigilin5197]

請問這繡框的內框是幾公分，布是什質料，好光滑

[@DingZihHan]

請問挑針具體該怎麼操作呢？