Static TV Adjustment For A 47RE Transmission

[@BiffsEquipment]

Really appericate all your videos.. I just found your channel a day ago and subscribed. You have some awesome Cummins 24v videos you had one of the best injector install videos I have seen.. people don’t realize how much work goes into making these videos, adjusting camera angles, explaining as you go and finding time to edit them for upload. I have a small KZbin channel of my own where I have some vids messing with my Cummins 24v but my channel is mainly tractor videos but I plan to do more 24v Cummins videos. I just ordered 7x.10 injectors from PDD for my truck along with their “pan off” 47re upgrade kit. Keep up the great work buddy, can’t wait to see what you do next to your Cummins 👍🏻

[@ChadMyers73]

Much appreciated and thank you for your support! I will check out your channel.

[@robertramirez1766]

Do I need this lever even though my truck is a 2006 and doesn’t have a cable throttle valve?

[@Rx7man]

since it doesn't move, you don't even need a heim joint, you can just use a bolt through a piece of angle iron welded to the all-thread and bolt it in, tighten the bolt after you have it set.. easy and cheap

[@ChadMyers73]

Absolutely but I wanted it to look a little bit better than that. LOL

[@Rx7man]

@@ChadMyers73 if you don't use chicken crap to weld, you can still make it look nice! ;)

[@ChadMyers73]

👍😂🤣

[@truthhurts2149]

Can anyone please help me figure out this false lockup of torque converter. 02 ram 2500 .Does it only once when I'm light on throttle. Lock unlocks right away and then locks into 4th and drives like normal. Seems like I've tried everything recommended. Alternator tests fine. Does it even when I disconnect it. It's bugging the crap out of me. This is a jasper reman put in a long time ago before I got the truck. I just adjusted tv cable and while it didn't fix it it made my shifts muchhhhh smoother. 2nd was hitting hard and now it's smooth as butta. Aww damn this is no Cummins vid.

[@ricardojuarez291]

Good morning chad.

[@ChadMyers73]

What’s up!

[@zachkreklow9427]

What did you all need to make your lever?

[@ChadMyers73]

I used a 1/4 x 1/4 hiem joint, 1/4 all thread and a short piece of angle iron

[@charlessadrin6965]

Spent half as much time, spent selling your merchandise and twice as much time like showing us how to take the clip off without breaking it thank you

[@ChadMyers73]

Sorry