Realy nice video Well explained And close-up shot To help people understand what you are doing. Thanks for it 😊
@nheng6913 Жыл бұрын
Great video, especially taking the time for the close ups to show what's going on.
@brucearney95362 жыл бұрын
Take a black sharpie and color the rail , you can really see it happen !
@robertshoemaker6204 Жыл бұрын
I like to pull the rail in first then true up with the pfeifer file jig....sharpie pen is a great idea will try that next time. Shoe in SW Oregon.
@brettholland91652 жыл бұрын
Great video!
@jimenote59245 ай бұрын
Excellent video! Be sure to brush away the filings when done. I’ve gotten some nasty metal splinters from this process.
@antoniosolari10136 ай бұрын
Thank you
@elitebowman538610 ай бұрын
Just what I was looking for, this video. Thanks for sharing this. I know about doing this procedure, I just haven't had any luck the way I have been trying to do it. I have tried a file and a sander. My brother is a Logger so he does it good but I haven't had any luck. What is the name of the dressing tool ? Thank you
@gunterbecker85285 ай бұрын
A carpenters square pushed against the side of the bar with sandpaper on the short side and Bob is u uncle. Lots cheaper n effective!
@IJustStep4 ай бұрын
Great idea
@markkevin21149 ай бұрын
Buddy Love it but what's the name of the tool?
@Geoff584 Жыл бұрын
Where you buy the fancy dancy?
@DimemanRobbie4 ай бұрын
I have an old Craftsman that the top/bottom of the bar look decent but the tip, where the guide pins are, one side has a deep groove and the outer edge is higher then the groove. Is it possible to dress the tip on the bar without messing up the guide pins?
@vectorspeedandconditioning972 ай бұрын
Should you pull the file instead of pushing when you file the other side so the file doesn’t get worn out?
@richardflagg30842 ай бұрын
Fireball Tool has a interesting video on back-dragging the file. I've always been told it would wear out the file too. I was enlightening.
@jaydee50912 жыл бұрын
What causes the bar to wear? I get deep groves in my bar...I'm running a 76inch wide milling bar... I appreciate your vids man!!
@richardflagg30842 жыл бұрын
At the end of the day, it's metal against metal you'll have some wear over time. You'll have to inspect how well the bar oil your using is lubricating the bar and make sure the oiler is turned up to it's max setting. Maybe try a different brand if you're having excessive wear or manually add some while milling. What type of set up do you have?
@jaydee50912 жыл бұрын
@@richardflagg3084 much appreciated 🙏 yea ill look into that forsure
@jbbolts Жыл бұрын
if you throw a chain it can cause burs... lack of proper oiling also
@richardfuerst52862 жыл бұрын
ok Richard, looks like I'm going to make a jig for me. 😁
@richardflagg30842 жыл бұрын
The best tools are made in the shop. I like how you think.