chainsaw review use

[@foodieloaded]

What is the fuel and 2T ratio?

[@noinchesdiy7269]

normal unleaded petrol. no need to mix oil in 4 stroke

[@lienagem]

Did you keep the choke on till the throttle clicked it in. I can get mine started following the procedure and what you went through on video? Second question, is the off switch spring loaded. I need to hold it in off position otherwise it just returned to run? Cheers

[@noinchesdiy7269]

doesn't it self cancel

[@lienagem]

Took the plug out and spark is ok, tipped a bit of fuel straight in and it ran for about three seconds and that's it. Seems to be a carby issue. This one might go back unfortunately

[@chuckmaddison2924]

Was looking at one of these this week. Think was $ 140 . Its big enough for what i need, and if it does ass up not a great loss. My only complaint is i would like a long pole on it like my old B&D which is getting a bit worn and battle damaged.

[@dalegunning2164]

Is that chainsaw 4"stroke?

[@noinchesdiy7269]

no 2

[@noinchesdiy7269]

no 4

[@martymartin2894]

No it's 2 stroke

[@davidpearce8756]

Good saw used all season

[@damonburroughs5283]

That saw , you need 2 stroke mix, Ur best to use proper 2 stroke oil at 50:1 and not the SAE30 they say. All chainsaws are 2 stroke to enable them to be used on the side etc. The manuals are confusing

[@noinchesdiy7269]

says 4 stroke on the box. I accidently ran it with mixed fuel the other day it worked fine. hopefully the take of unmixed fuel I ran through it was enough to clean it out

[@damonburroughs5283]

@@noinchesdiy7269 I stand corrected then. Interesting , there were some floating about but very briefly that used the engine oil as bar oil too which meant u could run out of engine oil, and now looking about it seem are sold in AUS still. Very interesting , I repair for a living , and generally the only non sump 4 strokes were 4 mixers where you still mixed as anything with a sump couldn't be used at angles. Think it's why Victa and Allen Hover used 2 strokes , you could mow down steep banks where no Briggs could go 😊 Nice one , good video

[@tomcochrane56]

Sounds like a box of broken bolts have fallen in the engine. You need to tune the carb.

[@noinchesdiy7269]

that's what chainsaws sound like

[@davidpearce8756]

U need to buy carb tool to adjustment mixture high and low

[@martymartin2894]

No don't tinker with them just use correct mix.

[@sidemansondays7582]

GOOD TIPS

[@jamespython5147]

Need to have a few close ups of what you are doing. Lighting is quite dull. Other than that, its an OK video.

[@noinchesdiy7269]

Thanks for feedback