CHARLIE PRICE VINTAGE SPEED PART 3 HOLLEY 94 REBUILD

This is continuation of Holley 94 part 2 rebuild . All your Holley 94 carb parts are available on our online catalog. SUBSCRIBE TO MY CHANNEL TO GET ALL MY VIDEOS. You can order from our catalog at WWW.VINTAGESPEED.COM. 772-778-0809 in Florida.

THANK YOU SIR FOR THE EDUCATIONAL EXPERIENCE. I FINALLY UNDERSTAND THE REBUILD PROCESS AND ITS LITTLE FLAWS DUE TO NOT KNOWING WHAT I DON'T KNOW AND NOT HAVING YOUR MACHINED PARTS.

[@nobuddyimportant2106]

Thank you for making these videos. Your knowledge is priceless!

[@RAK402]

Outstanding!

[@elborrachogrande]

After seeing the quality of parts you use in your videos, versus what i got in my rebuild kit, I'm gonna send you my 8BA for a rebuild.

[@salazarich]

good information thank you charlie

[@frekkledipped]

items installing are so small some are not visable kind of confusing if your not tuned to the lingo. I need one for the center carb rebuild

[@littlemike101]

Wish I could see more of the conical spring (accelerator return spring) that goes under your pump.........I couldn't see if one side of your spring was bigger than the other. I'm assuming the bigger side goes to the bottom and smaller side goes to the bottom of the pump.

[@charlesprice7897]

Yes small end up cp

[@ninja63639]

So I got your kit and I'm rebuilding my 94. I pulled the power valve and the retainer clip out for the check ball out but the ball itself is stuck. Any ideas on how to get that out or there?

[@charlesprice7897]

call me and I will tell you how to remove it 772 778 0809 charlie

[@ninja63639]

@@charlesprice7897 I got it out. I have the new one I got from you in. I have the accelerator pump in with the linkage reconnected but the valve only moves down about a quarter of an inch or so before it bottoms out. Does that seem right? I didn't pay attention to how far it moved when I disassembled it

[@72nortoncommando]

Have long and short squirrel nozzles in a box I got from a retired Ford tech..what r the applications for the short versus long?

[@charlesprice7897]

Sal--- Allways use short nozzles in 94's and all models with the 1 1/4" base bore.. 1 3/8 bore carbs use the long nozzle.

[@72nortoncommando]

@@charlesprice7897 Thanks for getting back, will be getting in touch at the shop

[@scottschmittmusic]

What do i do if i got the wrong power valve that leaks? I have no time to order another one

[@charlesprice7897]

Turn your pv into a pv plug by filling with epoxy like jb weld and run on jets only . Replace as soon as you can cp

[@chrisharris5800]

What happened to part 4?

[@13Clicks]

I’ve been looking for that power valve info forever. Thank you. I may be ordering one from you soon. Thank you for these top notch videos. Most of the videos on KZbin don’t have this quality and info.