Check this if you own an Arctic Cat ATV or UTV!

In this video I show how to replace a dry-rotted rubber intake gasket on Arctic Cats h1 engine. You might want to check yours if you own one. This also applies to other brands and models of ATVs and UTVs.
Arctic Cat intake boot part number for 550 & 700 models: 0437-069
Arctic Cat 0437-069 Intake Boot: amzn.to/48jXyvj
Gates 24032 2" Intake Hose: amzn.to/3S5W3v6
Subscribe to my channel: / @arcticfrost
Music I use: www.epidemicsound.com/referra... - get a 30-day FREE trial here!
Gear I use:
My Main Camera Canon EOS R amzn.to/3qLYHa2
My Main Lens 15-35mm amzn.to/3LNKZw
Vlog Mic amzn.to/3qNJ3La
DJI mic amzn.to/482mwih
Joby Gorillapod amzn.to/3IqITEx
Variable ND Filters amzn.to/3qLYVOq
My BROLL Lens amzn.to/3GKFn6t
The Action Cam I Use amzn.to/3Vr12pE
Tripod amzn.to/3Zg7rG2
My Secondary Camera amzn.to/3zIfXQQ
My Studio RGB lights amzn.to/3CumFhb
Best drone for Creators click.dji.com/ADw99EhPPhWfnt1...
Gimbal click.dji.com/AHF1d8RJGM8nTdt...
Camera Bag amzn.to/2V5OBot
Best Hands Free Camera Clip amzn.to/3IuF40P
My Battery Backup amzn.to/36faowp
My Editing Laptop amzn.to/47wCd0l
ATV Gear:
Handguards amzn.to/3xjJ7Vn
Heated grips amzn.to/3hfQ7gC
Tires amzn.to/3qVWOrq
Rack Extension amzn.to/2THCFZL
Speedlock amzn.to/3hiLylx
ROK straps amzn.to/3hGslJs
Helmet amzn.to/3dLkQQC
Warn VRX 35-S amzn.to/3FOgAeH
Winch stop amzn.to/32wVJyf
Tie downs bassproshops.vzck.net/jMQAn
Helmet amzn.to/3dLkQQC
Oil I use amzn.to/3hjXbbV
Hitch I use amzn.to/3kUPFXn
Dielectric Grease amzn.to/3dL6gsk
Bearing Greaser amzn.to/43rxv1P
T25 Torx amzn.to/3EssjA8
Battery charger amzn.to/3qNxfZk
Multimeter amzn.to/36MEgnr
Oil filter amzn.to/3jOw2PW
Spark plug amzn.to/3C24Zqw
Slime bassproshops.vzck.net/YrbmP
Tire patch kit bassproshops.vzck.net/rALNv
Milwaukee Chainsaw amzn.to/3CIyE7W
(Some links are affiliate and help support this channel to create more videos at no extra cost to you. Thank you for supporting and following along!)
Gear up with your very own ARCTICFROST apparel: teespring.com/stores/arcticfr...
Subscribe: / @arcticfrost
Follow: / arcticfrostatv
Check out these other ATV vids: • ATV
Dual Sport vids: • Adventure Rider
Side-by-Side vids: • Side-by-Side
Arctic Cat 550 Old vs. New: • Arctic Cat 550 Shootou...
ATV maintenance tips: • Rear Swaybar removal o...
#throttlebody #intakeboot #issue

[@rodneycross5015]

Do you know if this will work on a 04 400 or does it have the boot woth the bolts that goes in the intake ?

[@maz5907]

I should be acquiring an AC400 tomorrow in a trade form cement. Owner said it will run for some time then die; he has swapped the carb. My initial thought is fuel injector. I have not seen the vehicle yet. Thoughts?

[@ArcticFrost]

No reason to change the carb unless it’s damaged! You need spark, air and gas to run so just go through by process of elimination. Clean it with carb cleaner and compressed air. Load test the battery. Check the plug gap. Make sure you have fuel to the carb. Etc.

[@millennialmechanic]

They usually crack due to failed engine mounts. Upgrade the mounts to a solid mount. The prowlers may have a solid mount already, but it's a major issue on the atvs. Causing intake cracks and failure, case failure and worse.

[@ralphcannon2783]

this is not true at all

[@millennialmechanic]

It is a known problem. Why do you say otherwise?

[@ralphcannon2783]

@@millennialmechanic the intake boot is not connected to the frame on the prowler

[@millennialmechanic]

As stated in my first comment. Did you just read the first sentence?

[@ralphcannon2783]

@@millennialmechanic not clearly stated. you said may have a solid mount. that isn't correct either.

[@kevinhicks2818]

I’m looking at a 2009 700 that will only run on starter fluid? Could this be why it won’t run?

[@ArcticFrost]

Some around 2009 had bad fuel pumps, it should be getting 43psi. I would start checking there!

[@jimbob7072]

My artic cat 700 runs perfect

[@ArcticFrost]

Jim Bob Good to hear! Not all of them have this problem.

[@barrydoonan7362]

my 2011 700 XTX will not start but ran perfect when i put it away in nov. any ideas

[@ArcticFrost]

I would suspect the battery has gone bad. The clock has a little draw which over time will drain the battery. You should be able to get it load tested for free at an auto parts store.

[@jacobpatterson7583]

Does this make it idle like crap and die? And maybe even backfire? Tore into my 2006 500 atv because the shop had a long wait time and found a large Crack all the way through the intake boot. seems to run fine when on the throttle but backfires alot going down hill

[@ArcticFrost]

Yes, it would make the air/fuel mixture off by sucking too much air through a cracked boot. Hope you can get it fixed! 👍🏼

[@yernie1]

I've got a 2011 arctic cat 450 efi. Mine won't idle but will run decent if I give it throttle. A code came up for the throttle position sensor (p0121). Any idea how to fix that problem?

[@ArcticFrost]

Matt Yernesek Sounds like the TPS needs adjusted. You’ll need to use the diagnostic plug(under the seat) then loosen the screw and adjust it according to the service manual. Then reset the codes. I don’t have a 450 I can show you on but hopefully I can make a video on the process soon!

[@lawsonstandridge1384]

Mine is doing the exact thing bro did u ever get it?

[@yernie1]

@@lawsonstandridge1384 yes. It was the throttle position sensor. I bought a new one and found a KZbin video on how to adjust it. It was actually a pretty easy fix

[@billpiercey1156]

my 2006 artic cat 500 sputters when i gives it the trottle in 4wheel drive but when its in 2 wheel drive its ok other than it seems like it doesnt have full power

[@ArcticFrost]

Seems like a carb issue. Clean the carb with cleaner and compressed air to blow out the passages.

[@shanevmax34]

Do you know where the MAP sensor is on that setup? Also, do you know where the crank positioning sensor is on the engine. I have a code 12 and 13. I started by replacing the APS as it was only $30......but still spitting out the codes. (2011 Arctic Cat 550 ATV) Thanks for any advice!

[@ArcticFrost]

The MAP sensor is on the throttle body, I haven't known one of those to go bad. Have you cleared the codes after replacing? kzbin.info/www/bejne/fZulf6Giit6ep9E

[@ArcticFrost]

You'll also need to resync the EFI system after adjusting or replacing components on the throttle body. kzbin.info/www/bejne/a57RlGaGdrucnrM

[@ShuswapLivin]

How do you check codes. Mine backfires and nothing is coming up on my display

[@renesadventures829]

if it is cracked like that would it cause a loss of power?

[@ArcticFrost]

Rene Possibly. It may run rough or have a loss of power depending on how bad it is. If the crack is all the way through the rubber gasket it will cause the air/fuel mixture to be off and will be sucking dirty air in the throttle body that will cause damage to the engine.

[@GabesGarage.]

I have a artic cat 700 efi and my 4x4 stop working and when I put gas in the carb it starts to run you know why that happens ?

[@ArcticFrost]

I would start by checking the fuel pressure. It should have constant 43psi. The 4x4 may be a loose connection somewhere.

[@elevatormechanic3486]

my 08 650 H1 is a beast to start. Has been since new. Bought the Thundercat redution gear starter kit, and PC 680 battery hoping it would help! still hard to start, and even worse when warmed up. Any fixes for this issue that you know of.

[@ArcticFrost]

I would start by cleaning the carb thoroughly with both cleaner and compressed air. Also check or replace the fuel pump. Does it turn over freely?

[@elevatormechanic3486]

@@ArcticFrost it turns over freely when cold! when hot it drags heavily, and drains the battery.

[@slowride55]

Check the spark plug gap. Timing could be too advanced.

[@dirtysouthoffroad6402]

Check your valves and adjust as well bud. That’ll cause it sometimes.

[@elevatormechanic3486]

@@dirtysouthoffroad6402 actually I bought a starter from a different manufacturer! it now starts better then when new

[@grenouillepascalsebastien8874]

My Arctic cat 550 efi do only 60km/hr and it cut. So what can I do????

[@ArcticFrost]

You may check your spark plug, make sure the TPS is set correctly, Does it idle fine? kzbin.info/www/bejne/haXLqniqrKh9bpI

[@ralphcannon2783]

you do not need to remove all of the connectors to get this job done

[@ArcticFrost]

True! I was working on a bunch of other stuff on this one as well.

[@alexmcdougall3255]

My 2008 700 EFI arctic cat will start and idle sometimes when you hit the gas it will stall out so I give it more fuel she will run put it in drive And run after a long drive you can hear a back fire once in a while.... What is the problem if someone can help?

[@ArcticFrost]

You might check your fuel pump. Here are a few things you can check: kzbin.info/www/bejne/q2aXl2ywh9KFnNE

[@ursg9910]

Carburetor... sounds like choke is on

[@pabp7765]

@@ursg9910 he said its efi does not have a carburetor