Chrysler 300S / Dodge Charger Universal FRONT LIP (EZ Lip) | AnthonyJ350

[@tmurph247]

Looks great, i was considering this for my wifes 22 Forte GT because the front sits so low, but hadnt seen any real world applications until now .

[@AnthonyJ350]

And if you don't like it, it's not horrible to remove and you didn't spend a lot. With good prep they stay on for a long time.

[@SalmanHussain]

I’d be worried about the stickiness of the tape especially at higher speeds. I might try it on the daily and see how it turns out 😅

[@AnthonyJ350]

You can add push clips or stainless screws to the sides and center if you're worried.

[@dannycolemire2652]

Could you please help me with an issue I'm having with my 2003 Toyota Camry XLE 3.0 V6. About 4 months ago I decided to do some preventative maintenance lol. I cleaned the MAF sensor and throttle body but never removed the throttle body while cleaning it and I also used my finger to open up the butterfly to clean it. It wasn't dirty really but I did spray quite a bit or throttle body cleaner at it. Ok so I know that it's supposed to run a little rough and that's fine I just drove it for about 30 minutes and all was good after that or so I thought. Ever since at a cold start Only my RPM is high around 2000 and before cleaning it was a smooth 1200 RPM at a cold start and then dropped as it warmed up. What could have happened and please keep in mind it's only at a cold start? There's no codes and no vacuum leak. My car only has 125,000 miles. Some say I might have messed up the idle air control valve but my car doesn't have that so idk please help

[@AnthonyJ350]

Is the throttle body cable or electronic?

[@dannycolemire2652]

@@AnthonyJ350 electronic

[@AnthonyJ350]

@@dannycolemire2652 Was the battery connected when you cleaned it? Try disconnecting the negative terminal, push the horn and brake pedal to discharge any residual power. Leave it unhooked overnight. Then try taking it out on the highway the next day after reconnecting everything.

[@dannycolemire2652]

@@AnthonyJ350 I'll be perfectly honest the battery was not disconnected during the cleaning of the throttle body or the mass airflow sensor. But I did disconnect the battery terminals afterwards just long enough to clean the battery post then right back on

[@AnthonyJ350]

@@dannycolemire2652 Try the procedure I recommended and report back.