Cisco SD-WAN 010 - Service VPN1 Static Routes via CLI and Templates

[@floriancokl3142]

Thank you very much Rob for this wonderful series - fantastic job

[@atag512]

Really good content and easy explanations..

[@peterburston4978]

Love the show Rob!

[@tgnance81]

Constant learning #growth

[@speirsy]

Hey Rob, I joined the channel so I could have access to the configs. When I open your lab none of the devices have a config. In the shared area where you have the configs, only DC switch, Inet, and MPLS router configs are there. Will you be uploading the configs for all devices? I wanted to compare your config with my vEdge 1 config as I am not getting the VPN 1 OMP routes as showing at 8:18

[@RobRikerTechChannel]

the configs for the vEdges aren't available. The first few videos walk you through the basics via the CLI, then I switch over to templates. I'd recommend jotting down what I configure in the videos and then configure your vedges, you're probably missing something.

[@speirsy]

@@RobRikerTechChannel I've went through the vids a couple of times and can't seem to find what I'm missing. The vEdges on templates are working fine, at this point vEdge1 is still using CLI. Do you have any intention of sharing vEdge1 config in the future?

[@stevenwilliams7774]

@@speirsy vedge1 is going to be configured very similar to vedge2. What are you struggling with?

[@Zullastayskool01]

waiting for your further uploads Rob (y)

[@Dakerino-fz3rk]

Hi. how can i advertise a default route from HQ to branches, because i configure "ip route 0.0.0.0/0 vpn 0" in HQ so i can have internet access, but this defaut route is not advertised to other vEdges, the only way i can advertise is to configure "ip route 0.0.0.0/0 null0" but the problem with this one is that i lose my nat and thus cant access the internet

[@RobRikerTechChannel]

That's covered later on in the series in the NAT section

[@mehdi-lp6kd]

Excellent