Closed Loop Control of Boost Converter Simulation in MATLAB/Simulink!

Hey guys!
This video shows the simulation of a closed loop boost converter on MATLAB/Simulink. The design for the boost converter has been done on our previous video. This video uses a Discrete PI controller to control to O/p of a boost converter to 240 volts.
Boost converter design and simulation-
• Boost Converter design...
File Exchange Link www.mathworks....
---------------------------------------------------------------------------------------------------------------------------------------------------------
If you liked this video please share it with your friends and drop a like and subscribe by clicking the bell icon to not miss out on our latest content ;)
Comment down below what you think about this video,queries and requests are always welcome!
Stay tuned for more quality tutorials! Until then thanks for watching :)
Our website- howtoproject98...
Our Instagram handle- / theurbanscholar
Our Linkedin page- / the-urban-scholar

[@ghantermahs7916]

My favourite channel for Simulink from now onwards ❤️

[@TheUrbanScholar]

Thank you so much!

[@bubster2a]

Superb video!

[@TheUrbanScholar]

Thank you we'll never take your compliments for granted🙏

[@chinmaydas2169]

why we are using gain at the reference voltage side?

[@lehanm6689]

Sir, why is the additional PWM generator required when it is not connected to anything?

[@vasavisai1890]

Please make a video on Implementing the control design from Simulink to DSP board (C2000)

[@mugiwara5375]

what is the name of the block which is connected to 0.5 duty cycle?

[@abhishekraj2336]

Could you please explain, why is the base voltage taken as 240 for p.u. conversion?

[@saira9130]

Please do it for the buck boost converter also

[@tamilselvan9455]

How to calculate the PID VALUES

[@TheUrbanScholar]

We could find a reference paper for you if you mail us :)