CNC Mini Mill: Belt Conversion

In this video we install the Little Machine Shop belt pulley conversion on a Central Machine Mini Mill and perform a quick audio comparison before and after.

[@kennykash6089]

Great video. Nobody else could be bothered to show how hard it is to pry off that gear on the motor shaft at 6 minutes.

[@caseyvicory]

I'm loving these long form videos! Can't wait for more!

[@sand_creek]

Awesome content. Can't wait to see more!

[@RustyInventions-wz6ir]

Just found your channel and subscribed. Very nice video

[@lowcontrast]

Glad you are KZbin. Hope ya grow the channel

[@802Garage]

Nice work my dude! Well done video.

[@planetarybrentos]

Very informative video

[@Cbigs27]

The r2 scream lol

[@gerardvilleneuve2923]

Really like what you do.

[@codyworley6733]

Keep posting on here!!!

[@bfox89]

I did the same conversion but ran into an issue with the large pulley getting stuck when I tighten up the left handed bolt thing. Any suggestions

[@larrydeblieux8739]

What is the part number for conversion kit from Little Machine Shop ?

[@yottabit]

With the transmission delete is it “stuck” in high or low? Or what ratio

[@yottabit]

Nevermind, I read their install manual. For anyone else wondering the two speeds with the belt mod are controlled by switching the belt, and the internal Hi/Lo system is redundant. It will only make extra noise if left in but it isn’t mandatory to remove it

[@PatonMachines]

Good video Rusty! I've been following you since Tugski days! I think you might be interested in my stuff on here or TikTok!