Coaxial Fed patch antenna design using CST software

[@anuragkant3729]

How did u find the feed point from center

[@chetanshelar3680]

earlier u got a different s11 plot it was not dipping at 2.37 , how did u change it

[@etb29mayurisalve28]

which types of coax connector used here ? sma or else which

[@monmo4575]

My dear i want to Design microstrip array with coaxial cable feed is true or no

[@habibamuna7365]

Sir please tell the frequency range (MHz) of GSM 5G mobile Antenna .

[@hamzaasifkhan8421]

how to set the location of coaxial?

[@fredfrancium]

You can optimize it by parametric study at CST Software

[@tradtrad1000]

@@fredfrancium How do you parameter sweep location of the hole? When you do a boolean subtract, the component dissappears

[@fredfrancium]

@@tradtrad1000 You estimate the location, based on previous work and then you can move it 1 mm by 1, then each one that you get best results is the right place

[@tradtrad1000]

@@fredfrancium It's not what I meant, but I found that even after Boolean subtract, if the location is set as a parameter, you can still sweep the parameter and the location of the hole will change.

[@PRIYASHARMA-tj4le]

Inner and outer diameter of the coaxial feed is really that which are available in the market.... If yes then please provide me the link

[@burakozcan2167]

How we calculate center point of coaxial ?

[@ArunShaji]

This can be done by parametric sweep to get the impedance matching of 50 ohms

[@maheshkumaraghwariya6214]

@@ArunShaji plese share how to do that.

[@damlasevik8929]

Hi from Turkey sir, I'm a electrical and electronics engineering student. I have a question about designing. How can I reach you?

[@ArunShaji]

mail me at [e-mail]

[@aminajamal2418]

How can l change Szmax(1),zmax(1) name to S11

[@lailazannat5989]

Thank you so much

[@shouloluk]

jom harvy

[@albertshorts34]

Tese de casa