Cobalt rear wheel cylinder replacement

[@christopherg465]

Well did it fix your problems, id like to know because i have the same problem!!!

[@RktsledTv]

No but they did need replaced. Had to rebleed the master cylinder and that took care of the issue thanks for the comment

[@sawyerbennett8227]

Did you not have to back off the adjuster to get the shoes moved apart more to slip the wheel cylinder out? Video wasn't very thorough

[@sawyerbennett8227]

Also didn't say if this fixed your problem

[@RktsledTv]

Yes is did fix the issue. An no I didn’t have to back off the adjuster. But you can if you think it will make it easier for you to remove it. I didn’t have a issue not doing it

[@TheFruitingChamber]

Doing whole brake system already did booster calipers doing all rear got 1 side together but having issues with the grommets of the cylinder and advice there

[@TheFruitingChamber]

I'm guessing I should just put the drum on bleed it and inspect the gromet

[@RktsledTv]

That what I would try. I had some issues. But was able to get the to stay. Before bleeding. I would zip tie them on and then bleed the brakes then cut the zip tie off after there done. Put the drum back on hit the brakes again and check to see if they stayed.

[@TheFruitingChamber]

@@RktsledTv not losing fluid can tell i got the air outta rear i bleed pas r then dr gonna do pf then df right now. So I got the tensioners to where they touch with e brake off but not to much drag. How do these tensioners work?? I hear the clicking like i heard in some videos will happen i assume its both sides tensioners going 1 click am I just to keep pulling ebrake until it stops? Sorry to pester you!!

[@RktsledTv]

When you get them to the point they have little drag you want to drive the car they are self adjusting so if you put the car in reverse and speed up and slam on the brakes about 5 times. Or as many as needed and the clicking should go away.

[@RktsledTv]

Thanks for the comment. And if that don’t work I will have to look more into it but that has always worked for me.