Cocked hat Chief Mate Phase 1 TCN

[@akshaymehta502]

In first question the difference between the bearings are less than 180. So why do d we directly bisect it.. Instead of taking 1' off and then drawing it?

[@usmarinetech5484]

check the interior angle of 1st and 3rd bearing.

[@amittiwari2979]

Where you intersect 2nd and 3rd pl

[@kailashchandrapatra9200]

Can u pls elaborate how did u get fix in 2 nd question..means how u come to know that fix lies on that side..

[@utkarshtripathi2482]

In last part when difference is lesss than 180 degree you said first bisect interior then exterior ,but here you only bisected interior and write down the fix??????? Why????

[@MarineMotivation]

In first question difference between first and third was less than 180 despite your fixed was drawn inside . How is this possible. Though in your second question fix was out side . Which is correct. But about 1st question. Pls verify asap

[@thesailorship4372]

No its more than 180 u have to arrange in clockwise direction.which I explain in video

[@kailashchandrapatra9200]

Difference between 240 and 001 is less than 180,diff between 001 and 240 is more than 180,which One shall we take..it's bit confusing.kindly explain..

[@utkarshtripathi2482]

Please reply