Code P1259 VTEC Fault Code (part 2)

[@zTylers]

I have a 2000 Honda Accord, my check engine light came on after having a echeck. They said the solution could be the (VCT) Solenoid but the diagnostic code is (P1259). Should I check the VTEC System and see if that’s the problem? The car isn’t leaking any oil from the VTEC.

[@HoustonSpeedFreaks]

Check your oil level bro, mine ended up being a blown head gasket, it's was mixing my oil with coolant and burning it off making it run low on oil.

[@bernardmerrill3945]

I know I’m late but does a bad solenoid cause oil to leak

[@HoustonSpeedFreaks]

No but there are seals that's can go bad that can leak on the solenoids

[@SuperUPLIFTER]

I know I said it before. But anything to do with the lude and h22 helps me man. 👍

[@HoustonSpeedFreaks]

Of course but I'm far from stock with the prelude so only so much I can share on it that would actually help 🙃

[@dzungng7507]

Hi , the code p1259 is issues for EGR valves and Vtec solenoids . So the CO2( oxyzen censor) is not problem for this code ? Thanks a lot for your video.

[@HoustonSpeedFreaks]

P1259 is VTEC solenoid issues P0401 is EGR problems

[@memogonzalez9206]

aye bro i have the same issue and i’m leaking oil you think if i do that will it stop the leaking? i have a 3.0 accord 02

[@HoustonSpeedFreaks]

Depends on where it’s leaking oil from

[@chadCasselmanChad]

I already changed mine still getting code and really hard cold start

[@HoustonSpeedFreaks]

What's it doing on cold start just struggling to run right until it's warmed up?

[@quesorayo7962]

Hey man I am having the same issue, I’ve replaced the vtec solenoid cause it ran code p1259. It’s still running in limp mode unless I take out the 02 sensor for some reason but it seems okish, do you happen to have any suggestions?

[@johnathonedmonds2855]

Does it still run with 02 sensor out in limp mode will it take off and go up to speed or still limp

[@HoustonSpeedFreaks]

Which o2 sensor are you taking out the one before the cat or after?

[@isaiahsrios]

If it goes on limp mode it could be the ecu

[@HoustonSpeedFreaks]

Thank you man

[@arod31085]

Ima try to do this myself i have the same issue auto trans won't Rev past 4k (2001 2.3l lx)

[@HoustonSpeedFreaks]

Yeah figure out why it’s going into limp mode

[@raphaelbois2980]

Can you make a video on how to swap H22 inside of a Honda Accord 1998 and all the things that you have to buy to swap it .

[@HoustonSpeedFreaks]

And yes sir if you look I'm in the middle of building my other H22 for the Accord I'll be having a video come out for that soon 😉

[@raphaelbois2980]

Is there any possible way you can provide link for the V Tec solenoid

[@HoustonSpeedFreaks]

Check the description 😁

[@freaknazzty]

I’m having this issue but I’m pretty sure my car isn’t vtec

[@HoustonSpeedFreaks]

Hmmm what's it doing, I'd started with your spark plugs and wires bro

[@bree8830]

💯 appreciate it!

[@HoustonSpeedFreaks]

Anytime man!