Collapsible Bollard Installation and Application

[@Lcasta86L]

Hey man, very clean, interesting and professional. Good sNice tutorialt.

[@robsmithracing]

From experience, run into these slowly and nudge them and they will either pull out of the ground or the inner bars break and they fall over.

[@mikeranson3381]

Poor quality of installation for demonstration purposes. Each hole was drilled out with the bollard in situ. The guy doing the drilling was drilling on an angle. Why not just mark each hole, remove the bollard then drill vertically plum? I wouldnt use rawl bolts myself but chemical resin which is far more secure than a rawl bolt. To answer the question below from connor burn, You could double nut each bolt, or hammer down the head of the bolt to flatten out the top or both. I just picked up on the quality of the drilling for a demo video.

[@raza6075]

Gdje se moze nabavit . Ja BiH trebala 6 komada . Hvala

[@tonystipbits4944]

Should of hoovered the dust out then epoxy.

[@connorburn5496]

But what's stopping someone just removing the nuts?

[@Gravitics]

A security guard

[@relikvija]

4 dogos and a flying egg

[@chrisbailey7384]

The hinge can be padlocked.